FILLING PROCESS INTO POLYETHYLENE WITH ELASTIC MELT EXTRUDER
نویسندگان
چکیده
منابع مشابه
Grafting of Acrylamide to Low Density Polyethylene During Melt Processing
Acrylamide was grafted in low density polyethylene during melt processing in the presence of a free radical initiator using a torque rheometer in a closed system. Effects of processing time, acrylamide and benzoyl peroxide concentrations were studied. FTIR studies revealed that the degree of grafting increased by an increase in acrylamide concentration. Maximum grafting was obtained at 7 mi...
متن کاملSimulation of Stress Distribution near Weld Line in the Viscoelastic Melt Mold Filling Process
Simulations of interface evolution and stress distribution near weld line in the viscoelastic melt mold filling process are achieved according to the viscoelastic-Newtonian two-phase model. The finite volume methods on nonstaggered grids are used to solve the model. The level set method is used to capture the melt interface. The interface evolution of the viscoelastic melt in the mold filling p...
متن کاملPolymer crystal-melt interfaces and nucleation in polyethylene
Kinetic barriers cause polymers to crystallize incompletely, into nanoscale lamellae interleaved with amorphous regions. As a result, crystalline polymers are full of crystal-melt interfaces, which dominate their physical properties. The longstanding theoretical challenge to understand these interfaces has new relevance, because of accumulating evidence that polymer crystals often nucleate via ...
متن کاملTransient rheology of a polyethylene melt under shear.
Using nonequilibrium molecular dynamics simulation, we have studied the response of a C100 model polymer melt to a step change from equilibrium to a constant, high shear rate flow. The transient shear stress of the model polymer melt exhibits pronounced overshoot at the strain value predicted by the reptation model, in striking similarity to melts of longer, entangled polymer governed by reptat...
متن کاملgrafting of acrylamide to low density polyethylene during melt processing
acrylamide was grafted in low density polyethylene during melt processing in the presence of a free radical initiator using a torque rheometer in a closed system. effects of processing time, acrylamide and benzoyl peroxide concentrations were studied. ftir studies revealed that the degree of grafting increased by an increase in acrylamide concentration. maximum grafting was obtained at 7 minute...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Sen'i Gakkaishi
سال: 1977
ISSN: 0037-9875,1884-2259
DOI: 10.2115/fiber.33.t26