Fiber Orientation Distribution Predictions for an Injection Molded Venturi-Shaped Part Validated Against Experimental Micro-Computed Tomography Characterization
نویسندگان
چکیده
منابع مشابه
Fiber Orientation in Injection Molded Long Carbon Fiber Thermoplastic Composites
A set of edge-gated and center-gated plaques were injection molded with long carbon fiber-reinforced thermoplastic composites, and the fiber orientation was measured at different locations of the plaques. Autodesk Simulation Moldflow Insight (ASMI) software was used to simulate the injection molding of these plaques and to predict the fiber orientation, using the Anisotropic Rotary Diffusion an...
متن کاملImproving CT quality control of a micro injection molded part by multisensor data fusion
Acquiring holistic and accurate 3D measurements for industrial parts is highly demanded in the fields of quality control, process optimization and product development. The increasing complexity in the design and miniaturization make the task of holistic 3D data acquisition difficult. For the last few years, industrial computed tomography (CT) has emerged as a promising coordinate measuring tech...
متن کاملProduction and Analysis of Injection Molded Micro-Optic Components
Injection molding is a manufacturing technique that, through filling of a mold cavity (typically made from steel or aluminum alloys) with molten polymer, produces plastic parts. The geometry of the mold cavity is identical to the desired part shape, after taking into account thermal shrinkage. This manufacturing process is an economical and reliable way to mass-produce a variety of parts. Tradi...
متن کاملStudy on Effects of Molded Conditions on the Fiber Orientation and Electrical Conductivity of Injection Molded Bipolar Plate for Fuel Cell
Fuel cells constitute one of the most promising sources of clean energy for the 21 century and bipolar plate is an important component of a PEM fuel cell. Polymers filled with conducting fibers have been chosen as a candidate material for bipolar plates which needs to fulfill the surface conductivity requirement. In the present paper, effect of processing parameters including melt temperature, ...
متن کاملFiber Reinforcement Induced Warpage on Injection Molded Thermoplastics
1 Abstract The warpage characterizations of injection molded plastic parts are not standardized and very challenging due to its complex process. This paper presents a novel examination method of the deformation of injection molded plastic parts especially for fiber reinforced materials. A special, but simple part was introduced for the description of the effect of different technological parame...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Frontiers in Materials
سال: 2020
ISSN: 2296-8016
DOI: 10.3389/fmats.2020.00169