Fiber optic pH sensor based on phase fluorescence lifetimes
نویسندگان
چکیده
منابع مشابه
Fiber-Optic Pressure Sensor Based on π-Phase- Shifted Fiber Bragg Grating on Side-Hole Fiber
We present a fiber-optic pressure sensor based on a π-phase-shifted fiber Bragg grating (πFBG) fabricated on a sidehole fiber. Due to the resonance effect of a πFBG, its reflection spectrum features two notches that are dramatically narrower than the linewidth of a regular FBG of similar length. The narrow spectral notches allow high-resolution measurement of their spectral separation, signific...
متن کاملLow-cost high-performance fiber-optic pH sensor based on thin-core fiber modal interferometer.
A new fiber-optic pH sensor based on a thin-core fiber modal interferometer with electrostatic self-assembled nanocoating is presented. After inserting a segment of thin-core fiber into a standard single-mode fiber, high-order cladding modes are excited and interfere with the core mode to form an in-fiber modal interferometer. The side surface of the sensor is then deposited with poly(allylamin...
متن کاملFiber-Optic Vibration Sensor Based on Multimode Fiber
The purpose of this paper is to present a fiberoptic vibration sensor based on the monitoring of the mode distribution in a multimode optical fiber. Detection of vibrations and their parameters is possible through observation of the output speckle pattern from the multimode optical fiber. A working experimental model has been built in which all used components are widely available and cheap: a ...
متن کاملFiber Optic pH Sensor with Self-Assembled Polymer Multilayer Nanocoatings
A fiber-optic pH sensor based on a tilted fiber Bragg grating (TFBG) with electrostatic self-assembly multilayer sensing film is presented. The pH sensitive polymeric film, poly(diallyldimethylammonium chloride) (PDDA) and poly(acrylic acid) (PAA) was deposited on the circumference of the TFBG with the layer-by-layer (LbL) electrostatic self-assembly technique. The PDDA/PAA film exhibits a redu...
متن کاملA Fiber Optic Ammonia Sensor Using a Universal pH Indicator
A universal pH indicator is used to fabricate a fiber optic ammonia sensor. The advantage of this pH indicator is that it exhibits sensitivity to ammonia over a broad wavelength range. This provides a differential response, with a valley around 500 nm and a peak around 650 nm, which allows us to perform ratiometric measurements. The ratiometric measurements provide not only an enhanced signal, ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Analytical Chemistry
سال: 1993
ISSN: 0003-2700,1520-6882
DOI: 10.1021/ac00055a005