Fiber-Optic Directional Coupler Using HF Wet-Etching
نویسندگان
چکیده
منابع مشابه
Fiber-optic modal coupler using periodic microbending.
Periodic coupling between the various modes in an optical fiber is of current interest in interferometric and sensor applications. Coupling between the two cross-polarized modes of a single-mode birefringent fiber has been studied,1 as has coupling between the LP0 1 and LP 11 modes in a circularly symmetric fiber. 2 The latter case was achieved by periodically squeezing the fiber. It has been d...
متن کاملBroadband terahertz fiber directional coupler.
We present the design of a short broadband fiber directional coupler for terahertz (THz) radiation and demonstrate a 3 dB coupler with a bandwidth of 0.6 THz centered at 1.4 THz. The broadband coupling is achieved by mechanically downdoping the cores of a dual-core photonic crystal fiber by microstructuring the cores. This is equivalent to chemical downdoping but is easier to realize experiment...
متن کاملIntegrated fiber-optic coupler for very large scale integration interconnects.
The performance of very-high-speed integrated cir cuits and very-large-scale integrated circuits (VLSIC's) is impaired by limitations in the communi cation capacity among gates, chip, and boards.! Fi ber-optic interconnects are widely recognized as a po tential solution to this communication problem.27 However, no satisfactory means exists to couple a fiber to a detector on a VLSIC chip. We...
متن کاملEfficient quantum dot single photon extraction into an optical fiber using a nanophotonic directional coupler
M. Davanço, 2, ∗ M. T. Rakher, W. Wegscheider, D. Schuh, A. Badolato, and K. Srinivasan Center for Nanoscale Science and Technology, National Institute of Standards and Technology, Gaithersburg, MD 20899, USA Maryland NanoCenter, University of Maryland, College Park, MD 20742, USA Institute for Experimental and Applied Physics, University of Regensburg, D-93053 Regensburg, Germany Department of...
متن کاملQ-switching an all-fiber laser using acousto-optic null coupler
A new method for Q-switching an all-fiber laser is presented. It is based on induced acoustic long period grating operating on a null coupler, which acts as acoustically controlled tunable output coupler. Q-switching is achieved by switching on and off the acoustic wave in a burst mode, thereby generating laser pulses that are *400 times shorter than the acoustically controlled coupler’s rise t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Journal of Korean Institute of Electromagnetic Engineering and Science
سال: 2017
ISSN: 1226-3133,2288-226X
DOI: 10.5515/kjkiees.2017.28.1.25