Fermilab Accumulator Ring ultrahigh vacuum system

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Lattice Function Measurements in the Fermilab Accumulator Ring

The betatron phase advance between two points in a storage ring can be very accurately determined from a transverse beam transfer function measurement with DC beam. The phase advance can be determined from the difference in the phase response between an upper betatron sideband (N+Q line) and a lower betatron sideband (N-Q line) in an open loop network analyzer measurement between a kicker and a...

متن کامل

Design of the Sns Accumulator Ring Vacuum Systems*

Brookhaven is undertaking the design, construction and commissioning of the accumulator ring and the beam transport lines for the 1-GeV Spallation Neutron Source. The operating pressure of the accumulator ring vacuum system will be 10 Torr and is needed to minimize the beam-residual gas ionization. The vacuum requirement, the layout of the ring vacuum system, and the design of the vacuum chambe...

متن کامل

Searching for Antiproton Decay at the Fermilab Antiproton Accumulator

This paper describes an experimental search for antiproton decay at the Fermilab Antiproton Accumulator. The E868 (APEX) experimental setup is described. The APEX data is expected to be sensitive to antiproton decay if the antiproton lifetimes is less than a few times 100 000 years.

متن کامل

Search for antiproton decay at the Fermilab antiproton accumulator.

S. Geer, J. Marriner, M. Martens, R.E. Ray, J. Streets, W. Wester Fermi National Accelerator Laboratory, Batavia, Illinois 60510 M. Hu, G.R. Snow University of Nebraska, Lincoln, Nebraska 68588 T. Armstrong Pennsylvania State University, University Park, Pennsylvania 16802 C. Buchanan, B. Corbin, M. Lindgren, T. Muller† University of California at Los Angeles, Los Angeles, California 90024 R. G...

متن کامل

Wideband Rf System for the Fermilab Recycler Ring

A broadband RF system has been built for the new Fermilab Recycler Ring. It is designed to both bunch and capture beam during transfers and create multiple, moveable RF barrier buckets for azimuthal control of the stored antiproton beam. Beam will be bunched and captured using bursts of four RF cycles at 2.5 MHz. To maximize bucket area, the multiple barrier buckets will be generated by pairs o...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of Vacuum Science & Technology A: Vacuum, Surfaces, and Films

سال: 1986

ISSN: 0734-2101,1520-8559

DOI: 10.1116/1.573971