Fe–B and Fe–Si–B System Alloy Filaments Produced by Glass-Coated Melt Spinning
نویسندگان
چکیده
منابع مشابه
Enhanced Hydrogen Storage Kinetics of Nanocrystalline and Amorphous Mg2Ni-type Alloy by Melt Spinning
Mg₂Ni-type Mg₂Ni1-xCox (x = 0, 0.1, 0.2, 0.3, 0.4) alloys were fabricated by melt spinning technique. The structures of the as-spun alloys were characterized by X-ray diffraction (XRD) and transmission electron microscopy (TEM). The hydrogen absorption and desorption kinetics of the alloys were measured by an automatically controlled Sieverts apparatus. The electrochemical hydrogen storage kine...
متن کاملHeat Transfer during Melt Spinning of Al-7%si Alloy on a Cu-be Wheel
Transient heat transfer models of the single-wheel meltspinning process are developed and applied to quantify the effect of process variables including interface depressions on solidification, temperature evolution, thickness variations, and surface depressions in the cast product. Firstly, a transient one-dimensional heat-transfer model of the melt-spinning process called STRIP1D was developed...
متن کاملMelt-derived bioactive glass scaffolds produced by a gel-cast foaming technique.
Porous melt-derived bioactive glass scaffolds with interconnected pore networks suitable for bone regeneration were produced without the glass crystallizing. ICIE 16 (49.46% SiO(2), 36.27% CaO, 6.6% Na(2)O, 1.07% P(2)O(5) and 6.6% K(2)O, in mol.%) was used as it is a composition designed not to crystallize during sintering. Glass powder was made into porous scaffolds by using the gel-cast foami...
متن کاملCharacteristics of resist films produced by spinning
A model is presented for the description of thin films prepared from solution by spinning. Using only the centrifugal force. linear shear forces. and uniform evaporation of the solvent. the thickness of the film and the time of drying can be calculated as functions of the various processing parameters. The model is compared with experimental results obtained on positive photoresists and excelle...
متن کاملOptimal Control of Melt Spinning Processes
An optimal control problem for a mathematical model of a melt spinning process is considered. Newtonian and non–Newtonian models are used to describe the rheology of the polymeric material, the fiber is made of. The extrusion velocity of the polymer at the spinneret as well as the velocity and temperature of the quench air serve as control variables. A constrained optimization problem is derive...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Japan Institute of Metals
سال: 1980
ISSN: 0021-4434,2432-4701
DOI: 10.2320/matertrans1960.21.219