Femtosecond Laser Processing of Membranes for Sensor Devices on different Bulk Materials
نویسندگان
چکیده
منابع مشابه
Materials processing with a tightly focused femtosecond laser vortex pulse.
In this Letter we present the first (to our knowledge) demonstration of material modification using tightly focused single femtosecond laser vortex pulses. Double-charge femtosecond vortices were synthesized with a polarization-singularity beam converter based on light propagation in a uniaxial anisotropic medium and then focused using moderate- and high-NA optics (viz., NA=0.45 and 0.9) to abl...
متن کاملFemtosecond Laser Processing of Nitinol
The effects of femtosecond laser machining on surface characteristics and subsurface microstructure of a Nitinol alloy were studied. The femtosecond laser machining produced an average surface roughness of 0.2 μm. A re-deposited layer of 7 μm and a hardened layer of 70 μm were also resulted from the machining.
متن کاملProcessing microstructure on film by femtosecond laser
Selective laser patterning of thin films in a multilayer film is an emerging technology for fabrication of MEMS devices. A 775 nm Ti:sapphire laser (130 fs, 1 kHZ) was used to irradiate the thin film stacks with variations in process parameters such as feed rate and numerical aperture of objective lens. Femtosecond laser patterning of Au/Cr films which have the same thickness of about 1000 nm a...
متن کاملFemtosecond ablation scaling for different materials
We are making a comprehensive study of the ablation of elemental materials by femtosecond lasers. Specifically, we are examining the ablation of a wide range of metals, under vacuum and in ambient air, using 850-nm wavelength, 100fs laser pulses in an intensity range approaching and extending beyond the air ionization threshold. We compare ablation rates and examine in detail the morphology and...
متن کاملBulk Density of Granular Materials During Processing
Bulk density is an important process parameter for machines that transport, feed or process granular materials. Certain process variables have been shown to increase bulk density, such as the channel geometry at machines with rotational helical elements, the shape, dimensions and dimension distribution of granules, pressure, temperature, and vibration of the granular layer. The effect of the ra...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advances in Electrical and Electronic Engineering
سال: 2017
ISSN: 1804-3119,1336-1376
DOI: 10.15598/aeee.v15i3.2033