FEM simulation analysis of wire rod drawing process using the rotating die under Coulomb friction
نویسندگان
چکیده
منابع مشابه
On the optimum die angle in rod drawing process considering strain-hardening effect of material
In this paper, rod drawing process of strain-hardening materials is investigated by analytical, numerical and experimental methods. The classic upper bound solution, based on the assumption of perfect plasticity, has been extended to consider the work-hardening of the material during the drawing process. For a given process conditions and mechanical properties of the rod material, the power ter...
متن کاملOn the Optimum Die Shape in Rod Drawing Process Considering Work-Hardening Effect of Material
The assessment of the influence of the work-hardening of material on the optimum die profile and drawing force in rod drawing process is the main objective of the present paper. The upper bound solution, based on the assumption of perfect plasticity, has been extended to consider the work-hardening of the material during the rod drawing process through curved dies. Analytical results of drawin...
متن کاملForming of Multi layer Sheet Metal by Drawing Process: an Analysis and FEM Simulation
In this paper, the drawing process of multi-layer sheet metal through wedge shaped die has been analyzed using stream function and upper bound method. Typically a sandwich sheet contains three layers of metal, where the outer layers are of the same thickness and material and different from those of the inner layer. In this study, a new deformation model has been introduced in which inlet and ou...
متن کاملOptimum Die Design in Drawing of Square Section Rod from Round Bar
Drawing of square section rod from round bar can be done with two die shapes. In the first die shape, deformation starts from corners of the square and in second die shape, deformation starts from sides of square. This article has compared the drawing force for both die shapes and as a result optimum die shape was determined. Due to complexity of metal flow inside the die, analyzing of actual p...
متن کاملAdvances in wire drawing process by theoretical and numerical analysis
Ductile metal deformation processes aimed at production of wire of some sort are in use since over five thousand years, early ones dating back to the origins of copper and gold produc tion. Thin sheets, initially produced by hammering, were cut into thin strips suitable for ornamental pur poses. The introduction of die plate paved the way to round wire manufac turing, rather severe limitatio...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATEC Web of Conferences
سال: 2017
ISSN: 2261-236X
DOI: 10.1051/matecconf/201712300033