FEM burnishing simulation including roughness
نویسندگان
چکیده
منابع مشابه
High Performance FEM Simulation
Processor technology is still dramatically advancing and promises further enormous improvements in processing data for the next decade. On the other hand, much lower advances in moving data are expected such that the efficiency of many numerical software tools for Partial Differential Equations (PDEs) is restricted by the cost for memory access. In this article, we briefly discuss concepts for ...
متن کاملAnalysis of Surface Roughness and Micro-hardness in Roller Burnishing of Aluminum Alloy 6061
Burnishing is a chip-less finishing process, in which a hard roller or ball presses the surface layer of part to perform plastic deformation in the surface layer and produce improved finish, enhanced hardness and compressive residual stresses on the surface of special materials such as Aluminum and Brass. In the following research, the effect of input parameters such as feed rate, cutting speed...
متن کاملDetermination of Surface Roughness by Ball Burnishing Process Using Factorial Techniques
Burnishing is a method of finishing and hardening machined parts by plastic deformation of the surface. Experimental work based on central composite second order rotatable design has been carried out on a lathe machine to establish the effects of ball burnishing parameters on the surface roughness of brass material. Analysis of the results by the analysis of variance technique and the F-test sh...
متن کاملExperimental Investigation of the Influence of Burnishing Parameters on Surface Roughness and Hardness of Brass Alloy
Nanoparticles of iron oxide (Fe3O4) were obtained by Coprecipitation with synthesis time of 30, 60 and 90 min. The morphology of the samples was investigated by scanning electron microscopy (SEM) and structural characteristics were obtained by X-ray diffraction (XRD). The crystallite size was calculated from the spectrum X-ray diffraction with the application of the Scherrer equation and Winfit...
متن کاملAnalysis of GaN Based SAW Resonators including FEM Modeling
This paper proposes an analysis of two types of Surface Acoustic Wave (SAW) resonators composed of interdigital transducers (IDT) of 200 nm wide on GaN/Si devoted for GHz applications. Two finite element (FEM) models for basic periodic cells are given to demonstrate de characteristics of the resonators at different resonance frequencies. E-beam lithographical techniques have been used for the I...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Mechanik
سال: 2015
ISSN: 0025-6552
DOI: 10.17814/mechanik.2015.2.79