Features Design of Organic Rankine Cycle

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Development of a Low Temperature Geothermal Organic Rankine Cycle Standard

Low temperature geothermal systems are an abundant energy resource in New Zealand with over 260 sites with a resource temperature of 150°C and lower. The Organic Rankine Cycle (ORC) is the standard process for low temperature energy conversion with commercial ORCs utilizing temperatures as low as 90°C, with one site at Chena, Alaska (discussed below) utilizing temperatures as low as 74°C. The a...

متن کامل

Preliminary Design and Simulation of a Turbo Expander for Small Rated Power Organic Rankine Cycle (ORC)

Nowadays, the Organic Rankine Cycle (ORC) system, which operates with organic fluids, is one of the leading technologies for “waste energy recovery”. It works as a conventional Rankine Cycle but, as mentioned, instead of steam/water, an organic fluid is used. This change allows it to convert low temperature heat into electric energy where required. Large numbers of studies have been carried out...

متن کامل

Performance and design optimization of a low-cost solar organic Rankine cycle for remote power generation

Recent interest in small-scale solar thermal combined heat and power (CHP) power systems has coincided with demand growth for distributed electricity supplies in areas poorly served by centralized power stations. One potential technical approach to meeting this demand is the parabolic trough solar thermal collector coupled with an organic Rankine cycle (ORC) heat engine. The paper describes the...

متن کامل

A Design of the Organic Rankine Cycle for the Low Temperature Waste Heat

A presentation of the design of the Organic Rankine cycle (ORC) with heat regeneration and superheating processes is a subject of this paper. The maximum temperature level in the ORC is considered to be 110°C and the maximum pressure varies up to 2.5MPa. The selection process of the appropriate working fluids, thermal design and calculation of the cycle and its components are described. With re...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of Siberian Federal University. Engineering & Technologies

سال: 2019

ISSN: 2313-6057,1999-494X

DOI: 10.17516/1999-494x-0173