FE INVESTIGATION OF SURFACE BURNISHING TECHNOLOGY ABSTRACT

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Experimental Investigation of the Influence of Burnishing Parameters on Surface Roughness and Hardness of Brass Alloy

Nanoparticles of iron oxide (Fe3O4) were obtained by Coprecipitation with synthesis time of 30, 60 and 90 min. The morphology of the samples was investigated by scanning electron microscopy (SEM) and structural characteristics were obtained by X-ray diffraction (XRD). The crystallite size was calculated from the spectrum X-ray diffraction with the application of the Scherrer equation and Winfit...

متن کامل

Investigation of Sequential Cryogenic Hard Turning and Ball Burnishing Processes

K. Żak, W. Grzesik, M. Prażmowski, Opole University of Technology, Department of Manufacturing Engineering and Automation, Opole, Poland This paper presents a sequential machining process which incorporates CBN hard turning with cryogenic pre-cooling of the workpiece (CHT) and ball burnishing (BB). The main goal of this study was to select machining conditions enhancing the quality of parts mac...

متن کامل

investigation of variance of roller burnishing parameters on surface quality by taguchi approach

surface roughness of engineering parts is very significant property that effectively influences on the wear and fatigue strength. there are many methods for improving surface quality of engineering parts such as grinding, lapping and honing. one of the methods for improving surface quality is roller burnishing. roller burnishing improves surface quality of engineering parts by means of cold wor...

متن کامل

Analysis of Surface Roughness and Micro-hardness in Roller Burnishing of Aluminum Alloy 6061

Burnishing is a chip-less finishing process, in which a hard roller or ball presses the surface layer of part to perform plastic deformation in the surface layer and produce improved finish, enhanced hardness and compressive residual stresses on the surface of special materials such as Aluminum and Brass. In the following research, the effect of input parameters such as feed rate, cutting speed...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Cutting & Tools in Technological System

سال: 2020

ISSN: 2078-7405

DOI: 10.20998/2078-7405.2020.93.01