Fe Distribution in Zr-2.5Nb Pressure Tubes Having Variable Deformation Properties
نویسندگان
چکیده
منابع مشابه
Large variation of magnetic properties of amorphous Fe–Zr thin films with Ar pressure during sputtering
A large change is observed in the magnetic properties of amorphous Fe-Zr thin films sputtered at different Ar pressures. The change depends on the composition of the alloys and at compositions near 60 at.% Fe, for example, the magnetisation measured at 10 kOe increases 30-fold with an increase in the Ar pressure from 2 to 10 mTorr. The magnetic properties are well explained by a combination of ...
متن کاملImproving Mechanical Properties, Especially Increasing Tubes’ Strength by Micro structuring Metals Using Severe Plastic Deformation Method
Increasing material’s strength is of particular importance. Improving material’s mechanical properties such as strength could reduce the size and weight of the structure. The size and weight of the structure are among the effective parameters in design. Since the past a variety of methods have been developed to increase the strength of metals that are capable of increasing metals’ strength to a...
متن کاملCondensation heat transfer and pressure drop in flat tubes having different aspect ratio
In this study, condensation heat transfer coefficients of R-410A were obtained in flattened stainless tubes made from 5.0 mm inner diameter round tubes. The test range covered saturation temperature 45 , heat flux 10 °C kW/m, mass flux 100~400 kg/ms and quality 0.2~0.8. Results showed the effect of aspect ratio on condensation heat transfer coefficient was dependent on the flow pattern. For ann...
متن کاملAnalysis of pressure distribution and optimization of working conditions during push bending of circular tubes
Thin-walled tube bending is still to be considered a new and advanced technique. The process has been adopted into several industries such as aero and automotive. This process may produce a wrinkling, bulking and tearing phenomenon if the process parameters are inappropriate, especially for tubes with large diameter and thin wall thickness. Push bending process is one of the methods used for be...
متن کاملImproving Mechanical Properties, Especially Increasing Tubes’ Strength by Micro structuring Metals Using Severe Plastic Deformation Method
Increasing material’s strength is of particular importance. Improving material’s mechanical properties such as strength could reduce the size and weight of the structure. The size and weight of the structure are among the effective parameters in design. Since the past a variety of methods have been developed to increase the strength of metals that are capable of increasing metals’ strength to a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Microscopy and Microanalysis
سال: 2009
ISSN: 1431-9276,1435-8115
DOI: 10.1017/s1431927609096676