Fault Tolerant Triple Modular System Using FPGA
نویسندگان
چکیده
منابع مشابه
Fault Tolerant and Correction System Using Triple Modular Redundancy
An alternative way to have a fault less system is Fault Tolerant System, Triple Modular Redundancy (TMR) is used for making a fault tolerant system.. FPGA platform used in Altera Cyclone kit and Altera Quartus software is for functional and timing simulation. This model not only detects the faulty processor but also repair the faulty bits in the faulty processor .Fault detection are done over t...
متن کاملA Fault Tolerant Voter Circuit for Triple Modular Redundant System
Defect rate in Nanoelectronics is much higher than conventional CMOS circuits. Hardware redundancy can be a suitable solution for fault tolerance in nano level. A voter circuit is a part of a redundancy based fault tolerant system that enables a system to continue operating properly in the event of one or more faults within its components. Robustness of the voter circuit defines the reliability...
متن کاملTransfer Function of Triple Modular Redundancy Fault-tolerant sensors system
This paper formulates the transfer function of Triple Modular Redundancy (TMR) Fault-tolerant sensors system. The first attempt was to present a practicable model of a triple modular redundancy faulttolerant system for sensors working synchronously with same input. Analogues and digital sensors are separately modeled to show the difference in their transfer functions as resulted from their diff...
متن کاملFault Tolerant Air Bubble Sensor using Triple Modular Redundancy Method
Detection of air bubbles in the blood is important for various medical treatments that use Extracorporeal Blood Circuits (ECBC), such as hemodialysis, hemofiltration and cardio-pulmonary bypass. Therefore a reliable air bubble detector is needed. This study presents the design of a new fault tolerant air bubble detector. Triple Modular Redundancy (TMR) method is used on the sensor section. A vo...
متن کاملFault Tolerant Fpga Using Redundant Columns
Fault tolerance techniques are important to increase the yield of the VLSI chips in advanced fabrication technologies. In regular structure like FPGA, redundancy is commonly used for fault tolerance. Most of the techniques found so far in literature talks about software based change in configuration data. Here in this work we present a solution in which configuration bit stream of FPGA is chang...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bioscience Biotechnology Research Communications
سال: 2020
ISSN: 0974-6455,2321-4007
DOI: 10.21786/bbrc/13.14/108