Fatigue Strength of Aluminum Matrix Composite Reinforced with Aluminum Borate Whisker.
نویسندگان
چکیده
منابع مشابه
Fatigue crack growth resistance in SiC particulate and whisker reinforced P/M 2124 aluminum matrix composites
Fatigue crack growth is examined in P/M 2124 aluminum alloys reinforced with SiC particles (SiCp) and whiskers (SiCw) over a wide spectrum of growth rates from 10 to 10 m per cycle. Effects of aging treatment, orientation of crack growth direction with respect to the rolling direction, mean stress (or stress ratio), and reinforcement volume percent on the fatigue crack growth threshold are inve...
متن کاملStudy on Iraqi bauxite ceramic reinforced Aluminum metal matrix composite synthesized by stir casting
For the past decades researchers are showing immense interest to investigate the natural advantage of preparation of composites from minerals such as bauxite particles, and proved their effectiveness as cost effective reinforcing agents in fabrication of high performance composites. This study, is a new attempt in using the Iraqi natural bauxite powder with different proportions (2wt%, 4wt%, an...
متن کاملan investigation into the wear behaviour of aluminum (aa2124) matrix composite reinforced with intermetallic mosi2 particles
in the present work, the aa2124/25vol.%mosi2 composite was produced by powder metallurgy technique. the aluminum alloy 2124 powder was produced by gas atomization method and the mosi2 intermetallic particles were produced through combustion synthesis. the aa2124 matrix powder was mechanically blended with 25vol.%mosi2 using a ball milling mixer. the blended powder mixture was encapsulated and t...
متن کاملReinforcement architectures and thermal fatigue in diamond particle-reinforced aluminum
Aluminum reinforced by 60 vol.% diamond particles has been investigated as a potential heat sink material for high power electronics. Diamond (CD) is used as reinforcement contributing its high thermal conductivity (TC 1000 W mK ) and low coefficient thermal expansion (CTE 1 ppm K ). An Al matrix enables shaping and joining of the composite components. Interface bonding is improved by limited c...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 1994
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.41.774