Fatigue Crack Growth Characterisation of RAFM Steel using Acoustic Emission Technique
نویسندگان
چکیده
منابع مشابه
Detection of crack growth in rail steel using acoustic emission
Increased traffic speeds and axle loads on modern railways enhance rail track degradation. To eliminate track failure due to rail defects, a condition monitoring system requires methods for the early detection of defects which grow in service. Acoustic emission (AE) monitoring is the only non-destructive technique which might be applied online to study the defect growth under traffic loading. H...
متن کاملSteel bridge fatigue crack monitoring with broadband thin-film acoustic emission sensor
This paper presents a fatigue crack monitoring strategy termed close range acoustic emission (AE) signal sensing enabled by the use of low-cost thin-film AE sensor. In particular, flexible piezo paint has been used to make broadband thin-film AE sensors. This close-range AE signal monitoring method offers a promising new approach to AE-induced stress-wave sensing in the ultrasonic frequency ran...
متن کاملNondestructive Evaluation of Welding Crack Defects in Structural Component Of Track Crane Using Acoustic Emission Technique
On-line defects detection of structural component of track crane such as crane boom, outriggers, turntable and vehicle frame, is a difficult problem of nondestructive testing (NDT). In the present study, the usefulness of acoustic emission (AE) measurements for the detection of welding crack defects in the specimen made of HG70 steel, which is widely used for manufacturing structural component ...
متن کاملModeling of Corrosion-Fatigue Crack Growth Rate Based on Least Square Support Vector Machine Technique
Understanding crack growth behavior in engineering components subjected to cyclic fatigue loadings is necessary for design and maintenance purpose. Fatigue crack growth (FCG) rate strongly depends on the applied loading characteristics in a nonlinear manner, and when the mechanical loadings combine with environmental attacks, this dependency will be more complicated. Since, the experimental inv...
متن کاملStudy of Damaged Zone around Circular Opening Using Acoustic Emission Technique
One of the methods used to investigate the damaged zone in rock structure is the acoustic emission method. This method is based on receiving the elastic waves that are produced by deformation and cracking of the rock mass around the underground excavation. In this research, a study is conducted on the rock samples by a numerical method to investigate the damaged zone caused by the excavat...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Engineering
سال: 2013
ISSN: 1877-7058
DOI: 10.1016/j.proeng.2013.03.321