Fatigue Crack Growth Behavior of Multiphase Blends
نویسندگان
چکیده
منابع مشابه
Analyses of Fatigue Crack Growth and Closure Near Threshold Conditions for Large-Crack Behavior
A plasticity-induced crack-closure model was used to study fatigue crack growth and closure in thin 2024-T3 aluminum alloy under constant-R and constant-Kmax threshold testing procedures. Two methods of calculating crack-opening stresses were compared. One method was based on contact-K analyses and the other on contact crack-openingdisplacement (COD) analyses. These methods gave nearly identica...
متن کاملA cohesive model of fatigue crack growth
We investigate the use of cohesive theories of fracture, in conjunction with the explicit resolution of the near-tip plastic fields and the enforcement of closure as a contact constraint, for the purpose of fatiguelife prediction. An important characteristic of the cohesive laws considered here is that they exhibit unloadingreloading hysteresis. This feature has the important consequence of pre...
متن کاملThermo-Mechanical Fatigue Crack Growth of RR1000
Non-isothermal conditions during flight cycles have long led to the requirement for thermo-mechanical fatigue (TMF) evaluation of aerospace materials. However, the increased temperatures within the gas turbine engine have meant that the requirements for TMF testing now extend to disc alloys along with blade materials. As such, fatigue crack growth rates are required to be evaluated under non-is...
متن کاملStochastic Analysis of Fatigue Crack Growth
Due to cost and time limitations, experiments for fatigue crack growth are only feasible below certain cycle numbers. In this paper, it is investigated whether or not fatigue crack growth laws allow for an extrapolation of the statistics of the cycle number to reach a certain crack length from limited experimental data, and hence reduce costs.
متن کاملFatigue of Yttria-Stabilized Zirconia: II, Crack Propagation, Fatigue Striations, and Short-Crack Behavior
Fatigue crack propagation in 3Y-TZP was investigated using controlled surface flaws. A unique growth law strongly dependent on the maximum stress intensity factor and quadratically dependent on the amplitude of the range of stress intensity factor was established. This growth law was found to apply for both surface flaws and internal flaws and could be used to predict fatigue lifetime. The pres...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Solid Mechanics and Materials Engineering
سال: 2008
ISSN: 1880-9871
DOI: 10.1299/jmmp.2.417