Fatigue Characteristics of WC-1 mass%Cr3C2-12mass%Ni Alloys
نویسندگان
چکیده
منابع مشابه
FRACTURE AND FATIGUE BEHAVIOR OF WC-Co AND WC-CoNi CEMENTED CARBIDES
The fracture and fatigue characteristics of several cemented carbide grades are investigated as a function of their microstructure. In doing so, the influence of binder chemical nature and content (Co and 76wt%Co-24wt%Ni), as well as carbide grain size on hardness, flexural strength, fracture toughness and fatigue crack growth (FCG) behavior is evaluated. Mechanical testing is combined with a d...
متن کاملTEM INVESTIGATIONS OF WC-Co ALLOYS AFTER CREEP EXPERIMENTS
Carbide tungsten cobalt alloys were deformed in compression or in three point bending in a temperature range 1000-1350°C and in a stress domain 30-1000MPa. In these conditions, the stress exponent n of WC-CO alloys is a function of only the cobalt volurnic ratio and tends tow rds n = 1 for pure B carbide. The apparent activation energy is 550 kj mole. T.E.M. investigations on pure carbide defor...
متن کاملTHERMAL FATIGUE RESISTANCES OF 356 AND 413 CAST Al ALLOYS
Abstract: Thermal fatigue is a stochastic process often showing considerable scatter even in controlled environments. Due to complexity of thermal fatigue, there is no a complete analytical solution for predicting the effect of this property on the life of various components, subjected to severe thermal fluctuations. Among these components, one can mention car cylinder, cylinder head and pi...
متن کاملFatigue Behaviour in Fine Grained Aluminium Alloys
The effects of alloy production method on microstructure and hence fatigue crack growth rate and fracture mechanism have been examined for a variety of fine-grained/high dispersoid Al-Li-Mg-Zr and Al-Li-Cu-Mg-Zr alloys. Microstructures have been assessed by scanning and transmission electron microcopy, together with electron back scattered diffraction pattern assessment. In these fine-grained/h...
متن کاملStudy of Copper Bearing Alloys Corrosion Characteristics
This paper addresses investigation of the corrosion behavior of copper bearing anodes with high nickel content. Anodes are produced from different solid wastes formed during the copper or nickel row materials treatment. Nickel content in anode samples had values up to 10 mas %. The content of tin, lead and antimony was up to 1 % for each of elements. Sulphuric acid solution, concentration of 17...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 2004
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.51.368