Fatigue Behaviour of Friction Stir Welded AZ61 Magnesium Alloy
نویسندگان
چکیده
منابع مشابه
Corrosion Behavior of the Friction Stir Welded AZ31 Magnesium Alloy.
* IDMEC, Instituto Superior Técnico, Universidade de Lisboa, Av. Rovisco Pais, 1049-001 Lisboa, Portugal ** DEQ/ICEMS, Instituto Superior Técnico, Universidade de Lisboa, Av. Rovisco Pais, 1049001 Lisboa, Portugal. *** Department of Engineering Design and Production, School of Engineering, Aalto University, P.O. Box 1420, FI-00076 Aalto, Finland **** Faculdade de Engenharia da universidade do P...
متن کاملFatigue of Friction Stir Welded 2024-T351 Aluminium Alloy
Fatigue failure characteristics of friction stir welds in 13mm gauge 2024-T351 plate have been assessed. Failure occurred from either the weld region (nugget/flow arm) or from the material immediately surrounding the weld. Fatigue failure from the surrounding material was essentially conventional, initiating from large S-phase intermetallic particles and growing in a macroscopic mode I manner. ...
متن کاملCorrosion behaviour of friction stir welded AZ61A magnesium alloy welds immersed in NaCl solutions
The extruded AZ61A magnesium alloy plates of 6 mm thickness were butt welded using friction stir welding (FSW) process. The corrosion behavior of the welds was evaluated by conducting immersion test in NaCl solution at different pH value, immersion time and chloride ion concentrations. An empirical relationship was established incorporating pH value, immersion time and chloride ion concentratio...
متن کاملDuctility Improvement of an AZ61 Magnesium Alloy through Two-Pass Submerged Friction Stir Processing
Friction stir processing (FSP) has been considered as a novel technique to refine the grain size and homogenize the microstructure of metallic materials. In this study, two-pass FSP was conducted under water to enhance the cooling rate during processing, and an AZ61 magnesium alloy with fine-grained and homogeneous microstructure was prepared through this method. Compared to the as-cast materia...
متن کاملOptimizing the Process Parameters of Friction Stir Welded Joint of Magnesium Alloy Az31b
This paper deals with Friction stir welding of AZ31B Mg alloy by using H13 Tool at different rotational speeds and welding speeds .Experiments were conducted according to L4 Orthogonal array which was suggested by Taguchi. Optimum parameters for optimum Tensile strength, Hardness and Ductility were found with the help of S/N ratios. Therefore optimization of input process parameter is required ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: QUARTERLY JOURNAL OF THE JAPAN WELDING SOCIETY
سال: 2007
ISSN: 0288-4771
DOI: 10.2207/qjjws.25.224