Fatigue behaviour of fibre-reinforced composite T-joints
نویسندگان
چکیده
منابع مشابه
Fatigue behaviour of composite adhesive lap joints
This paper is concerned with a fatigue study of composite adhesive lap joints produced from a bi-directional woven E-glass fibres and polypropylene. The adhesive used was a Bostik 7452 (Rubber & Plastics Grade) ethyl cyanoacrylate type. The effects of layer orientation, lap joint length and water immersion on the fatigue behaviour were studied. The specimens were immersed in water during period...
متن کاملFatigue Damage Modelling of Fibre-reinforced Composite Materials: Review
This paper presents a review of the major fatigue models and life time prediction methodologies for fibrereinforced polymer composites, subjected to fatigue loadings. In this review, the fatigue models have been classified in three major categories: fatigue life models, which do not take into account the actual degradation mechanisms but use S-N curves or Goodman-type diagrams and introduce som...
متن کاملFatigue behaviour of short fibre reinforced polyamide: morphological and numerical analysis of fibre orientation effects
The fatigue behaviour of injection moulded short fibre reinforced polymers depends upon fibre orientation, as shown in experiments conducted with notched specimens injected through different injection gates. The different fatigue behaviour is related to the different local elastic properties, as determined by the different fibre orientation patterns, resulting into different strain distribution...
متن کاملFibre Orientation at Notches and Fatigue Behaviour of Short Fibre Reinforced Polyamide
Fatigue strength of injection moulded short fibre reinforced polymer components depends upon fibre orientation with reference to the acting stresses. For the case of a short glass fibre reinforced (SGFR) polyamide 6, this dependence was expressed through a relationship derived from the Tsai-Hill criterion [1], with the strong assumption that fibres were parallel to each other. This relationship...
متن کاملMachining of Fibre Reinforced Plastic Composite Materials
Fibre reinforced plastic composite materials are difficult to machine because of the anisotropy and inhomogeneity characterizing their microstructure and the abrasiveness of their reinforcement components. During machining, very rapid cutting tool wear development is experienced, and surface integrity damage is often produced in the machined parts. An accurate selection of the proper tool and m...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATEC Web of Conferences
سال: 2018
ISSN: 2261-236X
DOI: 10.1051/matecconf/201816507004