منابع مشابه
Microstructure and mechanical properties of pressureless sintered alumina-silver composites
The silver toughened alumina ceramics, which were fabricated via a conventional ceramic processing route using commercially available alumina and silver oxide powders as the starting materials, exhibit a higher fracture toughness (6 to 9 MPamo.5) than the monolithic alumina ceramic ( 2.5 to 3.0 MPamo.5). The weak interfacial bonding between the silver inclusions and the alumina matrix is charac...
متن کاملThe Comparison of MgO and TiO2 Additives Role on Sintering Behavior and Microstructures of Reaction-Sintered Alumina-Zirconia-Mullite Composite
Alumina-Mullite-Zirconia ceramic composites were prepared by reaction sintering of alumina, zircon mixture and the sintering aids of magnesia and titania at temperatures of 1400 and 1600 C for 2 hours. The development of different phases and microstructures of the composites were analysed to assess the relative influence of the additives on the formation of alumina-zirconia-mullite compos...
متن کاملDamage Behavior of Sintered Fiber Felts
The reduction of aircraft noise is important due to a rising number of flights and the growth of urban centers close to airports. During landing, a significant part of the noise is generated by flow around the airframe. To reduce that noise porous trailing edges are investigated. Ideally, the porous materials should to be structural materials as well. Therefore, the mechanical properties and da...
متن کاملDeformation and Grain Growth of Low-Temperature-Sintered High-Purity Alumina
9 = 0.6 I / s ' 7 = 6.0 0 7 = 2 4 i ti 3 = 6 0 Through close control over green-state powder processing, pure alumina ceramics of 0.5-pm grain size were obtained by sintering at 1250°C. The static grain growth of this material was modest at temperatures below 1300°C. However, dynamic grain growth occurred rapidly during superplastic deformation. Therefore, although the ultrafine-grained alumina...
متن کاملThe application of automated image analysis to dense heterogeneities in partially sintered alumina
his study used quantitative image analysis to examine the effect of powder forming method on a population of dense heterogeneities that could e imaged in partially sintered alumina using optical microscopy. Powder pressing resulted in a higher area fraction of dense heterogeneities than lip casting. Extreme value analysis was used to predict the size of the largest heterogeneity in the populati...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Precision Engineering
سال: 1968
ISSN: 0374-3543
DOI: 10.2493/jjspe1933.34.195