Failure criteria for C/SiC composites under plane stress state
نویسندگان
چکیده
منابع مشابه
Evaluation of Failure Criteria for Transversely Loaded Unidirectional Model Composites
A leading reason for the limited use of laminated composite materials in primary structural applications is that failure initiates in the ply oriented transverse to the direction of the applied load at a much lower strain than that which would cause the ultimate failure of the laminate. Previous studies indicate that transverse failure is manifested as either cavitation induced brittle failure ...
متن کاملFailure stress criteria for composite resin.
In previous work (Peters and Poort, 1983), the stress distribution in axisymmetric models of restored teeth was analyzed by finite element analysis (FEA). To compare the tri-axial stress state at different sites, they calculated the Von Mises equivalent stress and used it as an indication for weak sites. However, the use of Von Mises' theory for material failure requires that the compressive an...
متن کاملCompound Strip Method for Plane Stress
The compound strip method (CSM) for plates is an expansion of the finite strip method (FSM) and was developed to incorporate the effects of the support elements in the analysis of linear elastic plate systems. In this paper the CSM is further expanded to analyze structures such as stiffened plates under loads in the plane of the plate or the so called plane-stress condition. Examples of these t...
متن کاملSlope Stability Analysis Under Combined Failure Criteria
Strength reduction finite element method (SRFEM) has been widely used to analyze the slope stability. Strength Reduction Factor (SRF) is yielded as the slope Factor Of Safety (FOS) when a running-though shear failure zone comes into being, in which the Plastic Element EQuivalent strain (PEEQ) is employed as the judgment of shear failure initiation in this paper. Moreover, the filed variable is ...
متن کاملEffect of Stress Triaxiality on Yielding of Anisotropic Materials under Plane Stress Condition
The triaxiality of the stress state is known to greatly influence the amount of plastic strain which a material may undergo before ductile failure occurs. It is defined as the ratio of hydrostatic pressure, or mean stress, to the von Mises equivalent stress. This paper discusses the effects of stress triaxiality on yielding behavior of anisotropic materials. Hill-von Mises’s criteria for anisot...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Theoretical and Applied Mechanics Letters
سال: 2014
ISSN: 2095-0349
DOI: 10.1063/2.1402107