Failure analysis of a welded steel pipe at Kullar fault crossing
نویسندگان
چکیده
منابع مشابه
Health Monitoring of Welded Steel Pipes by Vibration Analysis
In the present work, structure health monitoring (SHM) of welded steel pipes was used to diagnosis their state via vibration based damage detection techniques. The dynamic quantities such as Frequency Response Functions (FRFs), mode shapes and modal parameters from structural vibration to detect damage were measured, set on linear averaging mode, with a maximum frequency of analysis of 3.2 kHz....
متن کاملResidual Stress Analysis and Fatigue Assessment of Welded Steel Structures
.............................................................................................................................. .i APPENDED PAPERS ............................................................................................................... ii PAPERS NOT INCLUDED IN THIS THESIS........................................................................ iii DIVISION OF WORK BETWEEN ...
متن کاملApplication Of Artificial Neural Network In Predicting The Weld Quality Of A Tungsten Inert Gas Welded Mild Steel Pipe Joint
The weld quality of Tunston inert gas welded joint has been investigated to identify the most economical weld parameters that will bring about optimum properties. Artificial neural network, has been used in the prediction and optimization of the Tunston inert gas weld of mild steel pipes. Neural network model was generated using the Levenberg-Marquardt algorithm with feed ward back propagation ...
متن کاملFatigue Assessment of Complex Welded Steel Structures
To improve the usage of material in fatigue loaded complex welded structures a better calculation method (based on FEA) is needed than what is available on the market and an improved management of weld quality. Improved FE-procedures are directly applicable to design of generic structural components within virtually all industries using CAD and FEtools, irrespective of industrial sector. More a...
متن کاملCold End Forming Of Welded Steel Tubes
The production of custom and specific tube end shapes by cold end forming using a die is generally limited to seamless tubular parts. Current research work in the field follows the same trend as that of industry and, therefore, there is no accumulated experience, no practical design rules, and no information available in the specialized literature concerning the utilization of tube end forming ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Engineering Failure Analysis
سال: 2017
ISSN: 1350-6307
DOI: 10.1016/j.engfailanal.2016.10.004