Failure analysis of a diesel generator connecting rod
نویسندگان
چکیده
منابع مشابه
Finite Element Analysis of Connecting Rod
Abstract—The connecting rod transmits the piston load to the crank causing the latter to turn, thus converting the reciprocating motion of the piston into a rotary motion of the crankshaft. Connecting rods are subjected to forces generated by mass and fuel combustion. This study investigates and compares the fatigue behavior of forged steel, powder forged and ASTM a 514 steel cold quenched conn...
متن کاملProcess-based tolerance assessment of connecting rod machining process
Process tolerancing based on the process capability studies is the optimistic and pragmatic approach of determining the manufacturing process tolerances. On adopting the define–measure–analyze–improve–control approach, the process potential capability index (C p) and the process performance capability index (C pk) values of identified process characteristics of connecting rod ...
متن کاملProcess capability improvement of an engine connecting rod machining process
Statistical process control is an excellent quality assurance tool to improve the quality of manufacture and ultimately scores on end-customer satisfaction. SPC uses process monitoring charts to record the key quality characteristics (KQCs) of the component in manufacture. This paper elaborates on one such KQC of the manufacturing of a connecting rod of an internal combustion engine. Here th...
متن کاملThe Analysis of Wheel Loader Diesel Engine Crankshaft Failure
The main purpose of this study is to review the cause for the crankshaft failure of six-cylinder diesel engine of a wheel loader after passing a short period of time. The failure had occurred after 4800 hours of in-service in the fifth crankpin of the crankshaft. Hardness and tensile tests were carried out to study their mechanical properties. Spectrophotometer machine was used to examine the c...
متن کاملStudy and Simulation of Shot peening Effect on Fatigue Life of a Powder Forged Connecting rod
Shot peening applies a residual compressive stress field (RCSF) on the surface of parts. It also shifts “crack nucleation sites” to sub-surface locations. A nondestructive method of measuring the stresses, Sin2ψ was utilized here and the stress values introduced to Ansys software. For this purpose, uniform stress in all directions was applied on the con rod. Loading on the rod in Ansys had thre...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Case Studies in Engineering Failure Analysis
سال: 2016
ISSN: 2213-2902
DOI: 10.1016/j.csefa.2016.06.001