Fabrication of super-hydrophobic surfaces on aluminum alloy substrates by RF-sputtered polytetrafluoroethylene coatings
نویسندگان
چکیده
منابع مشابه
Anti-corrosive Properties of CeO2 Conversion Coatings on Aluminum Alloy 2024 Prepared by Dip Immersion Method
As an alternative to chromate conversion coatings, rare-earth coatings especially cerium, because of the low toxicity, have attracted considerable attention. Using dip immersion method, cerium-based conversion coating was deposited on aluminum 2024. Corrosion resistance was studied in 3.5 wt.% NaCl solution using potentiodynamic polarization, electrochemical impedance spectroscopy, and surface ...
متن کاملAnnealing of gold nanostructures sputtered on polytetrafluoroethylene
Gold nanolayers sputtered on polytetrafluoroethylene (PTFE) surface and their changes induced by post-deposition annealing at 100°C to 300°C are studied. Changes in surface morphology and roughness are examined by atomic force microscopy, electrical sheet resistance by two point technique, zeta potential by electrokinetic analysis and chemical composition by X-ray photoelectron spectroscopy (XP...
متن کاملRemodeling of Super-hydrophobic Surfaces.
An experimental study on the underlying mechanisms of structured super-hydrophobic surfaces was recently published [ Butt, H.-J.; et al. How Water Advances on Superhydrophobic Surfaces. Phys. Rev. Lett. 2016, 116, 096101 . DOI: 10.1103/PhysRevLett.116.096101 ]. After depositing small drops of water, Butt's group inclined their surfaces to initiate movement. They examined the contact between the...
متن کاملFabrication and Characteristics of RF Magnetron Sputtered ITO Thin Films
Indium tin oxide (ITO) films have been deposited onto glass substrates by ifmagnetron sputtering without insitu substrate heating. The as-deposited films have an electrical resistivity of 5x1O a-cm, visible transmittance of about 85%, and infrared (IR) reflectance of above 80% at 5 jim. The effect of sputtering parameters on the deposition rate and the electrical and optical properties of ITO f...
متن کاملFabrication of TiC particulate reinforced Ni-50Fe super alloy matrix composite powder by mechanical alloying
Mechanical alloying is a powder metallurgy processing technique involving cold welding, fracturing, and rewelding of powder particles in a high-energy ball mill. In this work, NiFe-TiC composite powders were prepared by mechanical alloying process using planetary high-energy ball mill. The effect of TiC addition by weight percent on the NiFe solid solution formation, grain size, lattice paramet...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: AIP Advances
سال: 2014
ISSN: 2158-3226
DOI: 10.1063/1.4868363