Fabrication of Micro-Structured Polymer by Micro Injection Molding Based on Precise Micro-Ground Mold Core
نویسندگان
چکیده
منابع مشابه
Micro-layered-photolithography for Micro- Fabrication and Micro-molding
A novel process based on the principle of layered photolithography has been proposed and tested for making three-dimensional micro-structures. An experimental setup was designed and built for doing experiments on this micro-fabrication process. An ultraviolet (UV) excimer laser at the wavelength of 248 nm was used as the light source and a single piece of photo-mask carrying a series of two dim...
متن کاملFabrication of Polymeric Micro needle Array by Micromachining & Micro molding
Microneedles are expected to have greater demand in biomedical applications like sensing, electroporation & drug delivery in the future and there is need for development of fabrication process which is simple, economical and productive. Present work discusses about fabrication of PDMS (polydimethylsiloxane) micro needle array electrode for bio-potential signal measurement like EEG by micromachi...
متن کاملInfluence of Temperature and Polymer/ Mold Surface Interactions on Micro-feature Replication at Ambient Pressure in Micro Injection Molding
Microinjection molding is based on the concept of vario-thermal processing in which the injection unit heats the polymer and presses it into a micro featured mold. After the unit cools, the featured part is de-molded. An inherent problem with microinjection molding is poor feature replication. The polymer in the micro-cavity instantaneously freezes when it comes in contact with the mold wall th...
متن کاملEffects of Mold Surface Roughness on Compressible Flow of Micro-Injection Molding
be obtained as [5] Thus, the vol a surface roughness is δ=3S . ume fraction can he effective roughness height (δ) in terms of the average T to represent the physical surface roughness of the homogeneous pyramid roughness profile he equivalent three surface roughness. T -dimensional as the parameter to characterize the surface profilometer, , which can be measured easily using 3D a average...
متن کاملSimulation and modeling of macro and micro components produced by powder injection molding: A review
During the recent years powder processing technologies have gained much attention due to the less energy consumption and recyclable powders. Manufacturing of complicated parts by the conventional powder metallurgy (PM) method is hard due to the uniaxial pressure, which leads to the low design flexibility. In order to prevail these constraints, powder injection molding (PIM) process, which inclu...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Micromachines
سال: 2019
ISSN: 2072-666X
DOI: 10.3390/mi10040253