Fabrication of Metal Micro-tubes Using Superplastic Dieless Drawing Process
نویسندگان
چکیده
منابع مشابه
Process Simulation for Optimizing Superplastic Forming of Sheet Metal
Superplastic forming (SPF) is conducted in a heated, pressurized die where direct monitoring of critical SPF parameters is extremely difficult. Numerical models provide a critical means of tracking the forming process, allowing the applied gas pressure to be adjusted to maintain optimum SPF behavior throughout the forming process. This paper describes how the MARC finite element code was used t...
متن کاملFabrication of Wireless Micro Pressure Sensor Using the CMOS Process
In this study, we fabricated a wireless micro FET (field effect transistor) pressure sensor based on the commercial CMOS (complementary metal oxide semiconductor) process and a post-process. The wireless micro pressure sensor is composed of a FET pressure sensor, an oscillator, an amplifier and an antenna. The oscillator is adopted to generate an ac signal, and the amplifier is used to amplify ...
متن کاملForming of Multi layer Sheet Metal by Drawing Process: an Analysis and FEM Simulation
In this paper, the drawing process of multi-layer sheet metal through wedge shaped die has been analyzed using stream function and upper bound method. Typically a sandwich sheet contains three layers of metal, where the outer layers are of the same thickness and material and different from those of the inner layer. In this study, a new deformation model has been introduced in which inlet and ou...
متن کاملFabrication of micro-optical switch by post-CMOS micromachining process
This work presents the micro-machined 2-D switch array for use on free-space optical interconnect platform integrated with a digital 1×8 de-multiplexer control circuit together. Moreover, this device employs electrostatic actuation for light beam directions control. The CMOS-MEMS array-based optical platform contains 10×10 circular micromirrors switching spots, the diameter of each mirror is ab...
متن کاملHigh Yield Micro Fabrication Process for Biomimetic Artificial Haircell Sensors
We have developed artificial haircell sensors based on an improved plastic deformation magnetic assembly (PDMA) method. The PDMA method is uniquely capable of realizing three-dimensional microstructures in an efficient, ICcompatible manner. We have improved the design of the PDMA structure to significantly increase the yield by eliminating stress concentration. The robustness of the fabricated ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materia Japan
سال: 2010
ISSN: 1340-2625
DOI: 10.2320/materia.49.13