Fabrication of LGP Micro-Channels by Micro End-Milling and MR Fluid Jet Polishing
نویسندگان
چکیده
منابع مشابه
Fabrication of Biochips with Micro Fluidic Channels by Micro End-milling and Powder Blasting
For microfabrications of biochips with micro fluidic channels, a large number of microfabrication techniques based on silicon or glass-based Micro-Electro-Mechanical System (MEMS) technologies were proposed in the last decade. In recent years, for low cost and mass production, polymer-based microfabrication techniques by microinjection molding and micro hot embossing have been proposed. These t...
متن کاملFabrication of Microfluidic Channel Using Micro End Milling and Micro Electrical Discharge Milling
This paper discusses the fabrication of microfluidic channels using micro end milling and micro electrical discharge (ED) milling on metals and polymers. The width of the microchannels fabricated by micro end milling was 100-800 μm with 1-2 aspect ratio. The average surface roughness values were 100-200 nm and 80-120 nm on metals and polymers respectively. The end milling was found to form more...
متن کاملEvaluation of Superficial and Dimensional Quality Features in Metallic Micro-Channels Manufactured by Micro-End-Milling
Miniaturization encourages the development of new manufacturing processes capable of fabricating features, like micro-channels, in order to use them for different applications, such as in fuel cells, heat exchangers, microfluidic devices and micro-electromechanical systems (MEMS). Many studies have been conducted on heat and fluid transfer in micro-channels, and they appeared significantly devi...
متن کاملReview of Micro-Particles of Hydroxyapatite Nanoparticles by Ball Milling
Hydroxyapatite (HA) is the most important bioactive ceramics because of biocompatibility and structural similarity to the mineral part of bones and teeth of broad clinical application in the field of dentistry, orthopedic and coatings are Biomaterials. The aim of this study was to construct nano-hydroxyapatite micro particles using calcite, silica and zinc oxide using ball milling, powder, thes...
متن کاملModeling of three-dimensional cutting forces in micro-end-milling
A new nominal uncut chip thickness algorithm for micro-scale end-milling is proposed by considering the combination of an exact trochoidal trajectory of the tool tip and tool run-out, and then the actual uncut chip thickness may be obtained from a comparison between the current accumulative uncut chip thickness and the minimum chip thickness. Due to the intermittency of the chip formation, the ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of Materials Processing
سال: 2013
ISSN: 1225-696X
DOI: 10.5228/kstp.2013.22.2.80