Fabrication of high-value standard resistors
نویسندگان
چکیده
منابع مشابه
Implementing ultra-high-value floating tunable CMOS resistors
Introduction: Integrated high-value resistors (HVR) are key elements in many applications. Compact HVRs can be applied for biasing purposes or for implementing very-low-frequency filters [1, 2]. In addition to achieving high resistance, usually it is necessary to have good tuning capability of the resistor value, thus the controllability of the HVR is another important design issue. In this Let...
متن کاملNIST Measurement Service for DC Standard Resistors
At the National Institute of Standards and Technology (NIST), the U.S. representation of the ohm is based on the quantum Hall effect, and it is maintained and disseminated at various resistance levels by working reference groups of standards. This document describes the measurement systems and procedures used to calibrate standard resistors and current shunts of nominal decade values in the res...
متن کاملTransport behavior of commercially available 100-Ω standard resistors
Several types of commercial 100resistors can be used with the cryogenic current comparator to maintain the resistance unit, derived from the quantized Hall effect (QHE), and to disseminate this unit to laboratory resistance standards. Up until now, the transport behavior of these resistors has not been investigated. Such an investigation is of importance for carrying out comparisons that are cl...
متن کاملA guarded switching system for automatic selection of high value resistors under calibration
At IEN, a guarded switching system for automatic selection of high value resistors under calibration was developed and metrologically characterized. By means of this system it is possible to select and connect to the measurement system [1, 2] high value resistors in three terminals configuration. As a matter of fact, its guard system allows to reduce the effects due to all the dispersion curren...
متن کامل10, ×, 10 𝔾Ω Guarded Hamon Network for the Modified Wheatstone Bridge for High Value Resistors Calibration
At the National Institute of Metrological Research (INRIM), a Hamon guarded 10×100 M network was developed to improve the traceability levels of dc resistance at 1 G level. Utilizing and revisiting this project, a Hamon 10×10 G network is developed to extend the capabilities of the Hamon scaling technique up to 100 G . The novelty of the 10× 10 G network is its improved guard system, and the im...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Instrumentation and Measurement
سال: 1999
ISSN: 0018-9456
DOI: 10.1109/19.769595