Fabrication of Gas Atomized Co-Cr-Mo Alloy Powder and Microstructure of the Hot-Pressed Compacts
نویسندگان
چکیده
منابع مشابه
Study on the Microstructure of Hot Deformed Cu-28Zn Prealloyed Powder Compacts
The role of microstructure on hot deformation behavior of sintered Cu-28Zn prealloyed powder compacts was investigated by a series of isothermal hot compression tests in the temperature range of 550- 850°C at strain rates of 0.001, 0.01, 0.1 and 0.5 s-1, by taking into consideration the Hyperbolic Sine functional behavior to analyze the deformation behavior of the alloy. The results indicate th...
متن کاملCORROSION RESISTANCE OF Co-Cr-Mo ALLOY USED IN DENTISTRY ODPORNOŚĆ KOROZYJNA STOPU Co-Cr-Mo WYKORZYSTYWANEGO W STOMATOLOGII
The presented paper studies the effect of the casting technology on the corrosion resistance of Co-Cr-Mo alloy. The investigations were conducted on a commercial alloy with the brand name ARGELOY N.P SPECIAL (Co-Cr-Mo) produced by Argen as well as the same alloy melted and cast by the lost wax casting method performed by a dental technician. The corrosion behavior of the dental alloys in an art...
متن کاملAdditive Manufacturing of Co-Cr-Mo Alloy: Influence of Heat Treatment on Microstructure, Tribological, and Electrochemical Properties
Co-Cr-Mo alloy samples, fabricated using Laser Engineered Net Shaping – a laser-based additive manufacturing technology, have been subjected to heat treatment to study its influence on microstructure, wear, and corrosion properties. Following L9 Orthogonal array of Taguchi method, the samples were solutionized at 1200°C for 30, 45, and 60min followed by water quenching. Aging treatment was done...
متن کاملSpark Plasma Sintering of a Gas Atomized Al7075 Alloy: Microstructure and Properties
The powder of an Al7075 alloy was prepared by gas atomization. A combination of cellular, columnar, and equiaxed dendritic-like morphology was observed in individual powder particles with continuous layers of intermetallic phases along boundaries. The cells are separated predominantly by high-angle boundaries, the areas with dendritic-like morphology usually have a similar crystallographic orie...
متن کاملDetermining the Hot Deformation Temperature Range of Medium Carbon Ni-Cr-Mo Low Alloy Steels using Hot Tensile and Hot Torsion Tests
The aim of this study was to investigate the suitable temperature range for hot deformation of three medium carbon Ni-Cr-Mo low alloy steels by hot tensile and hot torsion tests. Hot tensile tests were carried out in the te,prature range of 850-1150°C at a constant strain rate of 0.1 s-1 until fracture. Then, the tensile flow behavior, hot ductility and microstructural evolution of the steels w...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals
سال: 2006
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet.70.275