Fabrication of Aluminum Foams with Small Pore Size by Melt Foaming Method
نویسندگان
چکیده
منابع مشابه
Simulation of Foaming and Deformation for Composite Aluminum Foams
In this study, at the first stage, the rupture criterion of bubbles wall in Aluminum metal foam liquid was investigated by using Lattice Boltzmann. The two phases modeling were accomplished by using a modified Shan-Chen model. This model was run for several bubbles in A356+3wt.%SiC melt system. Then, bubbles morphologies (virtual metallographic) for A356+3wt.%SiC foams were simulated. Results s...
متن کاملUnderstanding foams & foaming
Most of the common foams are a two-phase medium of gas and liquid with a particular structure consisting of gas pockets trapped in a network of thin liquid lms and plateau borders. Some well known foams are bubble baths, dishwater detergents and the foam head on beers. Many oils foam when trapped gas is suddenly released under conditions of an abrupt drop in pressure. In some re ners in which t...
متن کاملPore size and viscoelasticity of acoustic foams
We present linear viscoelastic measurement on a large frequency range (10 to 10 Hz) for cross-linked polymer open cell foams of same density and different pore size. This extend of frequency range is obtained by the validation of Time-Temperature Superposition (TTS) principle, commonly used with polymers. At higher frequencies, the shear moduli are independent on the pore size. In acoustical in...
متن کاملDAMPING PROPERTIES OF OPEN PORE ALUMINUM FOAMS PRODUCED BY VACUUM CASTING AND NaCl DISSOLUTION PROCESS
L. Dahil, Istanbul Arel University, Department of Mechanical and Metal Technologies, Turkey, A. Karabulut, Afyon Kocatepe University, Faculty of Technology, MechanicalEngineering, Turkey, S. Baspınar, Afyon Kocatepe University, Technical EducationFaculty, Turkey In this study,damping ratios of 3 samples made of aluminum foam material, which have diff erent-density pores, were calculated, the ef...
متن کاملPorous Structure Fabrication Using a Stereolithography-Based Sugar Foaming Method
Porous structure has wide application in industry due to some of its unique properties such as low density, low thermal conductivity, high surface area, and efficient stress transmission. Both templating and foaming agent methods have been used to fabricate porous structures. However, these methods can only fabricate simple geometries. In recent years, many studies have been done to use additiv...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Metallurgical and Materials Transactions B
سال: 2017
ISSN: 1073-5615,1543-1916
DOI: 10.1007/s11663-016-0815-6