Fabrication of Aluminum – Cr3C2 Surface Composites through Friction Stir Processing and Analyzing its Microstructural and Mechanical Evolution
نویسندگان
چکیده
منابع مشابه
Experimental Investigations on Microstructural and Mechanical Behavior of Friction Stir Welded Aluminum Matrix Composite
The welding of materials by applying Friction Stir Welding technique is a new solid-state joining technique. The main advantage of this method compared to the traditional joining process is that it minimizes problem-related to metal resolidification as the method incorporates no melting phase. In this experimental work, the effect of friction stir welding (FSW) technique on the microstructu...
متن کاملOn the fabrication and characterization of Al5083/Al2O3 surface nanocomposite via friction stir processing
In the present study, Al5083- Al2O3 nanocomposite was successfully prepared by friction stir processing (FSP) with rotational speed of 710 rpm and travel speed of 14 mm/min. In order to improve distribution of Al2O3 particles, a net of holes were designed on the surface of Al5083 sheet. The samples were characterized by optical and scanning electron microscopy (SEM), microhardness, tensile and ...
متن کاملFabrication of Al/Graphite/Al2O3 Surface Hybrid Nano Composite by Friction Stir Processing and Investigating The Wear and Microstructural Properties of The Composite
Friction stir processing was applied for fabricating an aluminum alloy based hybrid nano composite reinforced with nano sized Al2O3 and micro sized graphite particles. A mixture of Al2O3 and graphite particles was packed into a groove with 1 mm width and 4.5 mm depth, which had been cut in 5083 aluminum plate of 10 mm thick. Packed groove was subjected to friction stir processing in order to im...
متن کاملCharacterization of Aluminum-Based-Surface Matrix Composites with Iron and Iron Oxide Fabricated by Friction Stir Processing
Surface composite layers were successfully fabricated on an A 1050-H24 aluminum plate by dispersed iron (Fe) and magnetite (Fe₃O₄) particles through friction stir processing (FSP). Fe and Fe₃O₄ powders were packed into a groove of 3 mm in width and 1.5 mm in depth, cut on the aluminum plate, and covered with an aluminum sheet that was 2-mm thick. A friction stir processing (FSP) tool of square ...
متن کاملMulti-Track Friction Stir Lap Welding of 2024 Aluminum Alloy: Processing, Microstructure and Mechanical Properties
Friction stir lap welding (FSLW) raises the possibility of fabricating high-performance aluminum components at low cost and high efficiency. In this study, we mainly applied FSLW to fabricate multi-track 2024 aluminum alloy without using tool tilt angle, which is important for obtaining defect-free joint but significantly increases equipment cost. Firstly, systematic single-track FSLW experimen...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Archives of Metallurgy and Materials
سال: 2023
ISSN: ['1733-3490', '2300-1909']
DOI: https://doi.org/10.24425/amm.2019.130122