Fabrication and measurement of a flexoelectric micro-pyramid composite
نویسندگان
چکیده
منابع مشابه
Formulation of Composite Resistive Pastes for Fabrication of Micro- Heaters
We investigate in this work the formulation of composite resistive pastes based on epoxy resins and graphite for micro-heater manufacturing via thick-film technology. These resistive pastes are designed for screenprinting onto a printed circuit board (PCB) substrate; further coating with expandable polydimethylsiloxane (PDMS), a composite based on an elastomeric matrix and expandable microspher...
متن کاملDesign, Fabrication, and Micro-Reflectance Measurement of a GaAs/AlAs-Oxide Antireflection Film
We have designed and fabricated a double-layer antireflection (AR) film by selective oxidation of an epitaxially grown GaAs/AlAs heterostructure. The method presented in this work has the advantage that it is much simpler in processing than the conventional AR coating method. Furthermore, the fabrication steps for the AR films are fully compatible with the standard monolithic semiconductor devi...
متن کاملa comparison of linguistic and pragmatic knowledge: a case of iranian learners of english
در این تحقیق دانش زبانشناسی و کاربردشناسی زبان آموزان ایرانی در سطح بالای متوسط مقایسه شد. 50 دانش آموز با سابقه آموزشی مشابه از شش آموزشگاه زبان مختلف در دو آزمون دانش زبانشناسی و آزمون دانش گفتار شناسی زبان انگلیسی شرکت کردند که سوالات هر دو تست توسط محقق تهیه شده بود. همچنین در این تحقیق کارایی کتابهای آموزشی زبان در فراهم آوردن درون داد کافی برای زبان آموزان ایرانی به عنوان هدف جانبی تحقیق ...
15 صفحه اولMicro-layered-photolithography for Micro- Fabrication and Micro-molding
A novel process based on the principle of layered photolithography has been proposed and tested for making three-dimensional micro-structures. An experimental setup was designed and built for doing experiments on this micro-fabrication process. An ultraviolet (UV) excimer laser at the wavelength of 248 nm was used as the light source and a single piece of photo-mask carrying a series of two dim...
متن کاملNozzle Fabrication for Micro Propulsion of a Micro Satellite
⎯ To enable formation flying of micro satellites, small sized propulsion systems are required. Our research focuses on the miniaturization of a feeding and thruster system by means of micro system technology (MST). Three fabrication methods have been investigated to make a conical converging-diverging nozzle. These methods are reactive ion etching, femtosecond laser machining (FLM) and a combin...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: AIP Advances
سال: 2014
ISSN: 2158-3226
DOI: 10.1063/1.4904024