Fabrication and Machinability of Mullite-ZrO<sub>2</sub>-Al<sub>2</sub>TiO<sub>5</sub> Ceramics

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Mullite-alumina functionally gradient ceramics

Cracks free mullite-alumina Functionally Gradient Ceramics (FGC) have been obtained by sequential slip casting of Mullite-alumina slurries with diserent mullite/alumina ratios. These slurries were prepared with 65 % solids content and viscosities rangingpom 10 to 40 mPa.s. 7he presence of cracks perpendicular to the FGC layers have been attributed to residual stresses developed because of the m...

متن کامل

Fabrication and Investigation of Se-Ge Glass-Ceramics in the Presence of Ga and Sn Additives

The Chalcogenide glasses were fabricated by melting and quenching techniques in the Se-Ge system at the presence of 1mol% Ga and 3, 5, and 7mol% Sn. Differential Scanning Calorimetry (DSC) analysis was conducted to extract the heat treatment of the samples. Fourier Transform Infrared (FTIR) spectroscopy analysis was also performed in a range of 2-16µm. The Glass samples were heat-treated at 450...

متن کامل

Preparation of Silver- and Zinc-Doped Mullite-Based Ceramics Showing Anti-Bacterial Biofilm Properties

Zincand silver-doped mullite ceramic discs were prepared and tested as potentially resistant materials against bacterial adhesion and biofilm formation. Elemental analysis and X-ray diffraction studies showed that zinc ions were incorporated in the structural framework of the mullite, while silver ions remained outside the mullite crystal lattice, which allowed their slow (0.02 ppm/24 hours) le...

متن کامل

Superplastic Flow of Two-Phase Ceramics Containing Rigid lnclusions— Zirconia/Mullite Composites

A continuum theory for non-Newtonian flow of a two-phase composite containing rigid inclusions is presented. I t predicts flow suppression by a factor of (1 V)p, where V is the volume fraction of the rigid inclusion and q depends on the stress exponent and the inclusion shape. Stress concentrations in the rigid inclusion have also been evaluated. As the stress exponent increases, flow suppressi...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of the Korean Ceramic Society

سال: 2015

ISSN: 1229-7801

DOI: 10.4191/kcers.2015.52.6.423