Fabrication and characterization of High-Q NMR antenna coil using superconducting MgB2thin films

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Fabrication and femtosecond photoresponse studies of MgB2 superconducting thin films

We present fabrication and optical time-resolved photoresponse characterization of MgB2 superconducting thin films. The films were prepared on crystalline and flexible plastic substrates by vacuum co-deposition of B and Mg precursors and high-temperature annealing in an Ar or vacuum atmosphere. The post-annealed films exhibited very smooth surfaces and amorphous structures with nanocrystal incl...

متن کامل

Electromagnetic-Induced Quench of an Inner-Shim Coil for a REBCO High-Temperature Superconducting NMR Magnet

A RE(rare earth)Ba2Cu3Ox (REBCO) high-temperature superconducting (HTS) coil is a promising candidate to achieve a nuclear magnetic resonance (NMR) magnet operated at a magnetic field >23.5 Tesla (T), i.e. 1 H NMR frequency of 1 GHz. We developed and tested a 400 MHz (9.39 T) NMR magnet using an REBCO inner coil. The system included a low-temperature superconducting (LTS) shim coil inside the R...

متن کامل

Fabrication, characterization and investigation of gas sensing properties of MoO3 thin films

In this research, molybdenum oxide (α-MoO3) thin films were coated on glass substrates using spray pyrolysis technique. 0.05 M ammonium heptamolybdate tetrahydrate was used as precursor and deionized water as solvent. The effects of carrier gas pressure, during the spraying of the solution, on the structural, optical, morphological and gas sensing properties of thin films were studied. X-ray di...

متن کامل

Design and fabrication of a high-Q near-field probe for subsurface crack detection

Non-destructive detection and evaluation of invisible cracks in metal structures is an important matter in several critical environments including ground transportation, air transportation and power plants. In this paper, a high-Q near-field Microwave probe is designed and fabricated using defected ground structures for surface and subsurface crack detection in metal structures. For this purpos...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of Physics: Conference Series

سال: 2008

ISSN: 1742-6596

DOI: 10.1088/1742-6596/97/1/012137