Extrusion Behavior of Gas Atomized Mg Alloy Powders
نویسندگان
چکیده
منابع مشابه
Data on the densification during sintering of binder jet printed samples made from water- and gas-atomized alloy 625 powders
Binder jet printing (BJP) is a metal additive manufacturing method that manufactures parts with complex geometry by depositing powder layer-by-layer, selectively joining particles in each layer with a polymeric binder and finally curing the binder. After the printing process, the parts still in the powder bed must be sintered to achieve full densification (A. Mostafaei, Y. Behnamian, Y.L. Krime...
متن کاملWear Behavior and Microstructure of Mg-Sn Alloy Processed by Equal Channel Angular Extrusion
Mg-5wt.% Sn alloy is often used in portable electronic devices and automobiles. In this study, mechanical properties of Mg-5wt.% Sn alloy processed by Equal Channel Angular Extrusion (ECAE) were characterized. More precisely, its hardness and wear behavior were measured using Vickers hardness test and a pin-on-disc wear test. The microstructures of ECAE-processed Mg-Sn alloys were investigated ...
متن کاملSpark Plasma Sintering of a Gas Atomized Al7075 Alloy: Microstructure and Properties
The powder of an Al7075 alloy was prepared by gas atomization. A combination of cellular, columnar, and equiaxed dendritic-like morphology was observed in individual powder particles with continuous layers of intermetallic phases along boundaries. The cells are separated predominantly by high-angle boundaries, the areas with dendritic-like morphology usually have a similar crystallographic orie...
متن کاملMicrostructure and Aging Behavior of Nonflammable AZ91D Mg Alloy
Phase equilibria of AZ91D Mg alloys for nonflammable use, containing Ca and Y, were carried out by using FactSage® and FTLite database, which revealed that solid solution treatment could be performed at temperatures from 400 to 450C. Solid solution treatment of AZ91D Mg alloy without Ca and Y was successfully conducted at 420C and supersaturated microstructure with all beta phase resolved into ...
متن کاملDislocation Substructure Evolution during Hydrostatic Extrusion of Al Mg Si Alloy
Hydrostatic extrusion is a technique which allows to produce rods with ultra ne grains and unexpectedly enhanced mechanical properties caused by grain re nement. However, the mechanism of such a re nement is not fully understood at this stage. 6xxx aluminium alloys series are usually processed by extrusion. In this study, commercial 6082 aluminium alloy was extruded at ambient temperature in a ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Korean Powder Metallurgy Institute
سال: 2007
ISSN: 1225-7591
DOI: 10.4150/kpmi.2007.14.4.251