Extending the range of constant strain rate nanoindentation testing
نویسندگان
چکیده
منابع مشابه
Ultra High Strain Rate Nanoindentation Testing
Strain rate dependence of indentation hardness has been widely used to study time-dependent plasticity. However, the currently available techniques limit the range of strain rates that can be achieved during indentation testing. Recent advances in electronics have enabled nanomechanical measurements with very low noise levels (sub nanometer) at fast time constants (20 µs) and high data acquisit...
متن کاملAdvanced Nanoindentation Testing for Studying Strain-Rate Sensitivity and Activation Volume
Nanoindentation became a versatile tool for testing local mechanical properties beyond hardness and modulus. By adapting standard nanoindentation test methods, simple protocols capable of probing thermally activated deformation processes can be accomplished. Abrupt strain-rate changes within one indentation allow determining the strain-rate dependency of hardness at various indentation depths. ...
متن کاملHigh-strain-rate nanoindentation behavior of fine-grained magnesium alloys
rate nanoindentation behavior of fine-grained magnesium alloys. " Article is made available in accordance with the publisher's policy and may be subject to US copyright law. Please refer to the publisher's site for terms of use. The MIT Faculty has made this article openly available. Please share how this access benefits you. Your story matters. The effects of temperature and alloying elements ...
متن کاملExtending the Useable Range of Error Vector Magnitude (EVM) Testing
This paper discusses practical constraints of Error Vector Magnitude (EVM) measurements for high-coverage Radio Frequency Integrated Circuit (RFIC) device testing. Noise, distortion, spurious signals, and phase noise all degrade EVM, and therefore EVM provides a comprehensive measure of an RFIC’s quality of use in digital communications. New wireless standards with large instantaneous bandwidth...
متن کاملExtending the Radar Dynamic Range using Adaptive Pulse Compression
The matched filter in the radar receiver is only adapted to the transmitted signal version and its output will be wasted due to non-matching with the received signal from the environment. The sidelobes amplitude of the matched filter output in pulse compression radars are dependent on the transmitted coded waveforms that extended as much as the length of the code on both sides of the target loc...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Materials Research
سال: 2020
ISSN: 0884-2914,2044-5326
DOI: 10.1557/jmr.2019.408