Experiments of Surface Finish and Cutting Force on Free-Cutting Leaded Steels
نویسندگان
چکیده
منابع مشابه
Investigating Flank Wear and Cutting Force on Hard Steels by CBN Cutting Tool by Turning
In this research work a series of tests were conducted in order to determine flank wear and cutting force FY on hard AISI 440 C martensitic stainless steel and SCM 440 alloy steels. The operating parameters are cutting speed, feed rate and a constant depth of cut to investigate the flank wear and cutting force. No cutting fluid was used during the turning process. The cutting tool used was CBN ...
متن کاملthe effect of cutting speed on cutting force and surface quality in broaching of aluminum 7075
0
متن کاملStriation Formation and Surface Finish in Laser Cutting of Mild
The mechanisms of melt ejection and striation formation in laser cutting of mild steel are discussed. It is argued that the melt ejection from the cutting front is not a steady state process, but rather shows a cyclic phenomenon. The striation are strongly affected by the unstable characteristic of the thin liquid film on the cutting front during the melt ejection, together with the oxidation a...
متن کاملEffects of the Cutting Fluid Types and Cutting Parameters on Surface Roughness and Thrust Force
In this study, three different vegetable-based cutting fluids developed from raw and refined sunflower oil and two commercial types (vegetable and mineral based cutting oils), were carried out to determine for thrust force and surface roughness during drilling of AISI 304 austenitic stainless steel with HSSE tool. The uses of vegetable cutting oils was investigated in reducing thrust force and ...
متن کاملEffects of Friction and Cutting Speed on Cutting Force
Observations are made regarding the influence of cutting speed and friction on cutting force by way of finite element modeling. Simulations are validated by comparison of cutting forces and chip morphologies for the Al6061-T6. Analysis of cutting forces over a wide range of cutting conditions suggests an important role of the secondary shear zone in the decrease of cutting force as a function o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Japan Society of Mechanical Engineers
سال: 1962
ISSN: 0029-0270,2185-9485
DOI: 10.1299/kikai1938.28.414