Experimental Verification and Nonlinear Dynamic Response Analysis of a Rolling Element Bearing with Localized Defects

نویسندگان

چکیده

Abstract In this paper, the dynamic behavior of rolling element bearings with localized faults on inner and outer rings is investigated. A nonlinear mathematical model developed five degrees freedom considering rotor unbalance. bearing model, nonlinearity caused by Hertzian contact forces radial internal clearance. The fourth-order Runge–Kutta technique used to solve coupled equations motion numerically. Nonlinear vibration response housing can be obtained in both time frequency domains. An experimental verification numerical presented where measurements for defective ball are compared results. Envelope spectra results show similar that measured signals. parametric analysis conducted investigate effect system parameters using waveforms, orbit plots, bifurcation diagrams. demonstrate shows periodic, quasi-periodic chaotic motions because varying rotational speeds defect width. proposed contributes toward improved design better health monitoring practice.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

A New Restructured Shaded Pole Induction Motor- 3D Finite Element Analysis and Experimental Verification

Shaded pole induction motors, despite the simplicity and low cost, are difficult to analyze particularly in the equivalent circuit methods, due to the asymmetric structure, saturation, harmonics, inaccurate estimation of leakage inductances and skew. Hence, 3D numerical methods could be very useful in the design and optimization stage. This paper presents the 3D transient finite element analysi...

متن کامل

Rolling Element Bearing Vibration – Generation and Significance

Rolling bearings are one of the most important noise and vibration generator into mechanical constructions. Therefore, it is very important to have knowledge of the rolling element bearings influence on the level of noise and vibration in this systems. This paper deals with a basic forms for generation of vibration and noise of rolling element bearing and suggestions of vibration analysis signi...

متن کامل

A DWT and SVM based method for rolling element bearing fault diagnosis and its comparison with Artificial Neural Networks

A classification technique using Support Vector Machine (SVM) classifier for detection of rolling element bearing fault is presented here.  The SVM was fed from features that were extracted from of vibration signals obtained from experimental setup consisting of rotating driveline that was mounted on rolling element bearings which were run in normal and with artificially faults induced conditio...

متن کامل

Nonlinear Vibration Signature Analysis of High Speed Rotor Due to Defects of Rolling Element

This paper presents a mathematical model to investigate the nonlinear dynamic behavior of a high speed rotor-bearing system due to defects of rolling elements. Two defects have been considered for the study, one defect as off-sized rolling elements and other defect as rolling element waviness. In the formulation, the contacts between rolling elements and inner/outer races are considered as nonl...

متن کامل

Rolling Element Bearing Faults Detection, Wavelet De-noising Analysis

The wavelet de-noising technique with wavelet based function has been used in this paper for bearing fault detection. The applications of the wavelet de-noising show that the fault pulses in time-domain of the de-noised signals are easily to be detected as a result of removing the covering noise, which is not possible through the time-domain analysis of the original signal. Furthermore, the rec...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of Failure Analysis and Prevention

سال: 2022

ISSN: ['1864-1245', '1547-7029']

DOI: https://doi.org/10.1007/s11668-022-01466-x