Experimental validation of a dual loop control of two phases interleaved boost converter for fuel cell applications

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Experimental evaluation of four-phase floating interleaved boost converter design and control for fuel cell applications

Power electronic converters are essential part of hybrid fuel cell automotive application systems. The converter needs to provide high-voltage ratio for a wide range of input voltage. In addition, the converter should have high efficiency for a wide range of duty cycle control range. A four-phase floating interleaved boost converter (FIBC) is analysed and a small-signal AC model using an averag...

متن کامل

Adaptive sliding mode control of interleaved parallel boost converter for fuel cell energy generation system

This paper deals with the problem of controlling energy generation systems including fuel cells (FCs) and interleaved boost power converters. The proposed nonlinear adaptive controller is designed using sliding mode control (SMC) technique based on the system nonlinear model. The latter accounts for the boost converter large-signal dynamics as well as for the fuel-cell nonlinear characteristics...

متن کامل

Analysis and Experimentation of Soft Switched Interleaved Boost Converter for Photovoltaic Applications

Conventional energy sources are fast depleting due to poor conservation practises and excessive usage while the world’s energy demands are growing by minute. Additionally, the cost of producing conventional energy is rising also leading to an increase in harmful environmental pollution. Hence, there is a need to look at alternative energy sources such as sun, water and wind. Photovoltaic (PV) i...

متن کامل

A Novel Interleaved DC-DC Converter with Reduced Loss for Fuel Cell Vehicle Application

In this paper a novel four-leg interleaved DC-DC boost converter is proposed which is well suitable for fuel cell vehicles (FCV) application. The voltage stress of two switches of this converter is half of the conventional interleaved converters. Therefore, smaller and cheaper switches can be utilized. Also "on" state duration of the two of four switches are reduced in comparison with...

متن کامل

LM5032 Interleaved Boost Converter

The LM5032 dual current mode PWM controller contains all the features needed to control an interleaved boost converter. The two outputs operate 180 degrees out of phase and have separate current limit inputs for each channel. In addition to a high input voltage range, the controller contains all the auxiliary features needed to control a complete converter. Introduction A basic boost converter ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of Fundamental and Applied Sciences

سال: 2016

ISSN: 1112-9867

DOI: 10.4314/jfas.v8i2.11