Experimental study on rotary draw bending of magnesium alloy extruded tubes

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Experimental and Numerical Investigation on the Heat Treatment Effects of AA6063 Aluminum Alloy Tubes During Rotary Draw Bending

In this study, the effects of heat treatment of aluminum alloy on the tube bending process were investigated in the rotary draw bending process. As two experimental and numerical simulation methods were used to determine the wall-thinning, ovality, and spring back for extruded, annealed, and aged AA6063 aluminum alloy tubes in different bending angles and bend radii. Numerical simulations were ...

متن کامل

Analysis of the Rotary-draw Bending Process for Thin-walled Rectangular Aluminum Tube

The Rotary-Draw Bending (RDB) process is a distinguished process employed for the precision cold bending of a hollow tube with small radius bends using Numerical Control (NC) machines. This research presents an analytical model based on the power law hardening model for the RDB processing of rectangular thin tubes. Based on the constraints of the tube in the dies and its thinness, the plane str...

متن کامل

effect of mandrel, its clearance and pressure die on tube bending process via rotary draw bending method

one of the most prominent industries is bending, while using rotary draw bending method is known to be the most conventional approach for thin wall tube bending. pressure die is one effective tool which boosts the tube during the process and eventually improves the bending quality. other effective parameters are mandrel and the amount of clearance between tube and mandrel. in the present study,...

متن کامل

Grain Refinement and Enhancement of Mechanical Properties of Hot Extruded Rare-Earth Containing Magnesium Alloy

The effects of rare earth addition and hot extrusion process on the grain refinement of magnesium alloy were studied. The as-cast Mg-6Al-1Zn (AZ61) alloy had the average grain size of ~ 64 µm and its microstructure consisted of α-Mg and Mg17Al12 phase. By partial substitution of Al with Gd to reach Mg-4.8Gd-1.2Al-1Zn alloy, it was observed that the Mg17Al12 phase disappeared and two new interme...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: IOP Conference Series: Materials Science and Engineering

سال: 2020

ISSN: 1757-899X

DOI: 10.1088/1757-899x/770/1/012113