Experimental Study on Reservoir Physical Properties and Formation Blockage Risk in Geothermal Water Reinjection in Xining Basin: Taking Well DR2018 as an Example

نویسندگان

چکیده

The Xining Basin in Qinghai Province, China, is rich mid–low temperature geothermal resources, but the reinjection of water has not yet started. In this paper, physical properties rocks sampled from newly drilled well DR2018 were analyzed, and a series core flooding experiments was conducted to assess formation blockage risk during reinjection. experimental results show that reservoir low porosity 1.64–18.68% permeability 0.04–7.23 md. are weakly consolidated, movable clay sand particles account for 0.18–23.42 wt %, which significant rate salinity sensitivity. Even at flow velocity 0.31–1.64 cm/min, will drop by 35–53% after 25-144PV injection. An obvious fluctuation decline can also be observed as injected decreases. induced invasion low-content scaling suspended covered up migration cores. particle near-wellbore main reason cause well’s capacity.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

simulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water

abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...

Improvement of Water Saturation and Formation Factor Parameters in a Clastic Reservoir, Zagros Basin, SW Iran

Water saturation (Sw) is one of the most important petro-physical parameter for evaluating the clastic horizons of hydrocarbon reservoir, which can be calculated using Archie's equation. The Archie's parameters (m, a) are the major source of uncertainty in the calculation of Sw. In order to obtain Archie's parameters, a total number of 117 sandstone samples, having resistivity measurements from...

متن کامل

Optimization of Reinjection in Geothermal Reservoirs

Re-injection of produced geothermal water for pressure support is a common practice in geothermal field management. The location selection of the reinjection well and the rate of injection is a challenging subject for geothermal reservoir engineers. The goal of optimization for this type of problem is usually to find one or more combinations of geothermal re-injection well locations that will m...

متن کامل

A Comparative Study of the Neural Network, Fuzzy Logic, and Nero-fuzzy Systems in Seismic Reservoir Characterization: An Example from Arab (Surmeh) Reservoir as an Iranian Gas Field, Persian Gulf Basin

Intelligent reservoir characterization using seismic attributes and hydraulic flow units has a vital role in the description of oil and gas traps. The predicted model allows an accurate understanding of the reservoir quality, especially at the un-cored well location. This study was conducted in two major steps. In the first step, the survey compared different intelligent techniques to discover ...

متن کامل

An experimental and theoretical study on the physical properties of Al doped ZnO thin films

In this research, ZnO thin films with Al impurity as dopant were coated onto cleaned glass substrates by the spray pyrolysis technique. Crystal structure of the thin films was studied via XRD, and UV-vis spectroscopy was carried out to investigate their optical properties. Finally, in order to study the effect of Al impurity in ZnO thin films, the band structures of both pure and doped systems ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Energies

سال: 2021

ISSN: ['1996-1073']

DOI: https://doi.org/10.3390/en14092671