Experimental study on film cooling performance of imperfect holes
نویسندگان
چکیده
منابع مشابه
An Experimental Study of Momentum-Preserving Shaped Holes for Film Cooling Using PSP and PIV
An experimental investigation was conducted to study the performance of film cooling injection from a cylindrical hole and a “W-shaped” hole. A Pressure Sensitive Paint (PSP) technique was used to map the spatial distribution of film cooling effectiveness on the surface of the test plate based on a mass-transfer analogy. The effects of mass flux ratio and density ratio on film cooling effective...
متن کاملFilm cooling effectiveness in single row of holes: First moment closure modeling
The present article focuses on the evaluation of a first-moment closure model applicable to film cooling flow and heat transfer computations. The present first-moment closure model consists of a higher level of turbulent heat flux modeling in which two additional transport equations for temperature variance kθ and its dissipation rate εθ are ...
متن کاملShape optimization of impingement and film cooling holes on a flat plate using a feedforward ANN and GA
Numerical simulations of a three-dimensional model of impingement and film cooling on a flat plate are presented and validated with the available experimental data. Four different turbulence models were utilized for simulation, in which SST had the highest precision, resulting in less than 4% maximum error in temperature estimation. A simplified geometry with periodic boundary conditions is de...
متن کاملExperimental Investigation into the Hydrodynamics Effects of Slot Film Cooling on a Cylindrical Model
An experimental study of hydrodynamics of film cooling is performed by using a single longitudinal slot on a cylindrical model simulated to the leading edge of the gas turbine blade. The model is set up into the test section of an open-circuit induced flow wind tunnel which provides the main flow. The injected air, as a secondary film flow, produced from a high pressure compressor is considered...
متن کاملfilm cooling effectiveness in single row of holes: first moment closure modeling
the present article focuses on the evaluation of a first-moment closure model applicable to film cooling flow and heat transfer computations. the present first-moment closure model consists of a higher level of turbulent heat flux modeling in which two additional transport equations for temperature variance kθ and its dissipation rate εθ are considered. it not only employs a time scale that is ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Chinese Journal of Aeronautics
سال: 2018
ISSN: 1000-9361
DOI: 10.1016/j.cja.2018.04.001