Experimental Study on Bending Behavior and Finite Element Simulation Analysis of Glued Wood Inverted T-beam
نویسندگان
چکیده
منابع مشابه
Using Finite Element Software to Simulation Fracture Behavior of Three-point Bending Beam with Initial Crack
using computation software to simulate fracture behaviors of structures can shorten the time to estimate safety of engineering structures and reduce a lot of cost of experiment. However three dimensional numerical simulation for fracture process is a challenging issue, because the convergence and accuracy are not easily obtained and high computational cost is generated. In this paper, three new...
متن کاملAxial Crushing Analysis of Sandwich Thin-walled Tubes using Experimental and Finite Element Simulation
Application of impact energy absorption systems in different industries is of special significance. Thin-walled tubes, due to their lightness, high energy absorption capacity, long crushing length and the high ratio of energy absorption to weight, have found ever-increasing application as one of the most effective energy absorption systems. In this research, through carrying out experimental t...
متن کاملExperimental and Finite Element Simulation of Nano-indentation on Metal Matrix Composites: Hardness Prediction
The scientific importance of nanocomposites are being increased due to their improvedproperties. This paper is divided into two parts. First, Al-Al2O3 nanocomposite wasproduced by using ball milling technique followed by cold compaction and sintering.Microstructure and morphology studies were done through SEM, TEM, and EDX anal-ysis on the produced powder. The mechanical properties of the produ...
متن کاملSimulation and Experimental Study of Vibration and Noise of Pure Electric Bus Transmission based on Finite Element and Boundary Element Methods
Since the electric motor of pure electric vehicle replaced the engine, the "masking effect" disappears, and the problem of vibration and noise of the transmission becomes prominent. This is generated during the gear meshing and is transmitted to the housing through the shaft and bearing. Thereby, radiation noise of the housing are generated. The prediction and analysis...
متن کاملfinite element analysis of the pseudo-elastic behavior of shape memory alloy truss and beam
the pseudo-elastic behavior of shape memory alloy (sma) truss and cantilever beam are investigated. brinson’s one-dimensional material model, which uses the twinned and detwinned martensite fractions separately as internal variables, is applied in the algorithm to establish the sma stress-strain characteristics. this material model also incorporates different young’s modulus for austenitic and ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Engineering Science and Technology Review
سال: 2020
ISSN: 1791-9320,1791-2377
DOI: 10.25103/jestr.131.20