Experimental Study on a Standing Wave Thermoacoustic Prime Mover with Air Working Gas at Various Pressures

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Experimental studies of a thermoacoustic Stirling prime mover and its application to a cooler

An acoustic field spontaneously induced in a thermoacoustic prime mover consisting of a looped tube and resonator is determined through simultaneously measurements of pressure P and velocity U. A thermal efficiency of the thermoacoustic prime mover of this type has been reported to reach 30%. The measurements of the acoustic field in the present system revealed that a phase lead of U relative t...

متن کامل

Selection of the optimum prime mover and the working fluid in a regenerative organic rankine cycle

A regenerative organic Rankine cycle (RORC) is modeled and optimized for the use of waste heat recovery from a prime mover (PM). Three PMs including, a diesel engine, a gas engine, and a microturbine are selected in this study. Four refrigerants including isobutane, R123, R134a, and R245fa are selected. The nominal capacity of the PM, PM operating partial load, turbine inlet pressure, condenser...

متن کامل

Load Effect on the Starting Performance of a Standing Wave Thermoacoustic Engine

Introduction A thermoacoustic engine is a device absorbing heat at the hot heat exchanger and releasing heat at the cold heat exchanger while producing acoustic work as an output. Engines are built to carry a load, which in the case of an acoustic device, might include a thermoacoustic refrigerator [4], a (possibly linear) electric generator [2] etc. Coupling between the engine and the load inf...

متن کامل

Department of Prime Mover Engineering

Technological innovations in the field of prime movers have recently made a rapid progress as represented in cars and engines. In the Department of Prime Mover Engineering, research, design and manufacture are carried out with respect to lean burn engine, alternative fuel engine, electric vehicles such as hybrid cars, linear motor cars by use of magnetic levitation, and energy-saving solar cars...

متن کامل

Study of Standing-Wave Thermoacoustic Electricity Generators for Low-Power Applications

This paper is concerned with the study of low-cost, low-power thermoacoustic electricity generators. Based on target electrical output power values of 50 and 100 W, three standing wave prototypes (of both one-stage and two-stage prototypes) integrating a commercial loudspeaker with different coupling arrangements are conceived. Each stage consists of a square-pore stack sandwiched between hot a...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of Physics: Conference Series

سال: 2016

ISSN: 1742-6588,1742-6596

DOI: 10.1088/1742-6596/710/1/012031