Experimental study of subcooled flow boiling heat transfer on micro-pin-finned surfaces in short-term microgravity

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Experimental measurement of heat transfer coefficient and mass of deposited CaSO4 in subcooled flow boiling condition

Fouling is a common, fundamental and costly problem in heat transfer systems, which reduces thermal efficiency of equipment, increases the energy loss and causes strong damage to the heat transfer equipment in various industries. The main causes of fouling on the heat transfer surfaces are salts with inverse temperature-solubility in the fluid which calcium sulfate is one of the most important ...

متن کامل

Flow Boiling Heat Transfer on Micro Pin Fins Entrenched in a Microchannel

Flow boiling of 1-methoxyheptafluoropropane (HFE 7000) in 222 m hydraulic diameter channels containing a single row of 24 inline 100 m pin fins was studied for mass fluxes from 350 kg /m2 s to 827 kg /m2 s and wall heat fluxes from 10 W /cm2 to 110 W /cm2. Flow visualization revealed the existence of isolated bubbles, bubbles interacting, multiple flow, and annular flow. The observed flow patte...

متن کامل

Critical heat flux for subcooled flow boiling in micro-channel heat sinks

Critical heat flux (CHF) was measured and examined with high-speed video for subcooled flow boiling in micro-channel heat sinks using HFE 7100 as working fluid. High subcooling was achieved by pre-cooling the working fluid using a secondary low-temperature refrigeration system. The high subcooling greatly reduced both bubble departure diameter and void fraction, and precluded flow pattern trans...

متن کامل

Heat Transfer from Finned Surfaces

conv hAs (Ts T ) where As is the heat transfer surface area and h is the convection heat transfer coefficient. When the temperatures Ts and T are fixed by design considerations, as is often the case, there are two ways to increase the rate of heat transfer: to increase the convection heat transfer coefficient h or to increase the surface area As. Increasing h may require the installation of a p...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Experimental Thermal and Fluid Science

سال: 2018

ISSN: 0894-1777

DOI: 10.1016/j.expthermflusci.2018.05.003