Experimental study of load bearing cold-formed steel wall systems under fire conditions
نویسندگان
چکیده
منابع مشابه
Experimental Investigation on Cold-formed Steel Wall Plate System
A series of tests on cold-formed steel (CFS) wall plate system subjected to uplift force at the mid span of the wall plate is presented. The aim of the study was to study the behaviour and identify the modes of failure of CFS wall plate system. Two parameters were considered in these studies: 1) different dimension of U-bracket at the supports and 2) different sizes of lipped Cchannel. The lipp...
متن کاملExperimental Investigation on Cold-Formed Steel Foamed Concrete Composite Wall under Compression
A series of tests on cold-formed steel foamed concrete (CSFC) composite walls subjected to axial load were proposed. The primary purpose of the experiments was to study the mechanical behavior and identify the failure modes of CSFC composite walls. Two main factors were considered in this study: 1) specimen with pouring foamed concrete or without and 2) different foamed concrete density ranks (...
متن کاملAnalysis of Sheathed Cold-Formed Steel Wall Studs
The strength of sheathed wall systems is substantially greater than unsheathed walls with the same studs. Testing on studs sheathed on both sides with dry gypsum board demonstrate strength increases as large as 70% over unsheathed studs (Miller and Peköz 1993, Miller and Peköz 1994). The current AISI Specification for sheathed wall stud systems are complicated, only apply when the sheathing is ...
متن کاملPerformance of Infilled Profiled Steel Sheet Dry Board PSSDB Load Bearing Wall (TECHNICAL NOTE)
This paper describes the testing of Profiled Steel Sheet Dry Board (PSSDB) load bearing wall system. Experimental tests were conducted on various PSSDB wall samples, with and without infill materials to study its effect on the PSSDB load bearing wall performance. A proprietary profiled steel sheet, Ajiya Cliplock (0.48 mm thick) attached to Cemboard (10 mm thick) on one side, and Cemplank (10 m...
متن کاملOn Cold-Formed Steel Construction
Powder-actuated (also referred to as low velocity or powder-driven) fasteners are commonly used to attach cold-formed steel framing members, usually a track, to a concrete or structural steel support. Although commonly used, their behavior is less well understood than other fasteners such as screws, bolts and welds. The AISI Cold-Formed Steel Design Manual does not explicitly address powder act...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Thin-Walled Structures
سال: 2013
ISSN: 0263-8231
DOI: 10.1016/j.tws.2013.01.005