Experimental Study and Numerical Simulation of the FLINDT Draft Tube Rotating Vortex
نویسندگان
چکیده
منابع مشابه
2D Numerical Simulation of a Micro Scale Ranque-Hilsch Vortex Tube
In this study, fluid flow and energy separation in a micro-scale Ranque-HilschVortex Tube are numerically investigated. The flow is assumed as 2D, steady,compressible ideal gas, and shear-stress-transport SST k-W is found to be a bestchoice for modeling of turbulence phenomena. The results are in a good agreementwith the experimental results reported in the literature. The results show that f...
متن کاملNumerical Study of a Pipe Extension Effect in Draft Tube on Hydraulic Turbine Performance
Draft tube of Francis type hydraulic turbine usually consists of: cone, elbow and diffuser. On the contrary, in some power stations an extra pipe should be added to the draft tube at the bottom of cone because of installation limitation. In this paper, this special case has been numerically studied. To this end CFD analysis was applied to simulate all parts of hydraulic turbine. A homogeneous m...
متن کاملNumerical and Experimental Study of Residual Stress Measurement and Thickness Distribution of T-shape Steel Tube Produced by Tube Hydroforming
Tube hydroforming (THF) process is used to produce the complex components from the initial cylindrical tubes. In this paper, T- shape component was formed using a tube hydroforming machine and the residual stresses of hydroformed tube was determined by hole drilling method. Subsequently, the thickness distribution and residual stresses of final tube were investigated using experimental and fini...
متن کاملFast numerical simulation of vortex shedding in tube arrays using a discrete vortex method
Vortex shedding may occur in tube arrays, resulting in strong excitation forces at discrete frequencies. In the past the Strouhal numbers governing vortex shedding in these systems were determined primarily by experiment. This paper presents a computationally inexpensive method of numerical simulation for the unsteady flow through a rigid normal triangular tube array which determines both the f...
متن کاملNumerical and Experimental Study of Residual Stress Measurement and Thickness Distribution of T-shape Steel Tube Produced by Tube Hydroforming
Tube hydroforming (THF) process is used to produce the complex components from the initial cylindrical tubes. In this paper, T- shape component was formed using a tube hydroforming machine and the residual stresses of hydroformed tube was determined by hole drilling method. Subsequently, the thickness distribution and residual stresses of final tube were investigated using experimental and fini...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Fluids Engineering
سال: 2006
ISSN: 0098-2202,1528-901X
DOI: 10.1115/1.2409332