Experimental study and modelling of abrasive water jet cutting of aluminum alloy 2024
نویسندگان
چکیده
منابع مشابه
Crack Behavior of the Aluminum Alloy 2024 Under Fretting Conditions
The initial stage of fretting fatigue crack growth is significantly influenced by tangential force induced by fretting action along the contact surface where a mixed-mode crack growth is involved. Fretting crack behavior of aluminum alloy 2024 was studied, taking into account the problem of contact asperities. Finite element was used for the determination of the stress field near the contact su...
متن کاملAbrasive Water Jet Cutting (awjc) of Co-cr-mo Alloy Investment Castings in the Medical Device Industry
Investment castings (usually involving ceramic based shells) have traditionally been separated from the mould tree using an abrasive cutting operation. While material removal rates are relatively high, the process unfortunately suffers from poor accuracy control that often necessitates further finishing operations. Following an overview of key considerations in investment casting including tree...
متن کاملEffect of Aging Condition on Semisolid Cast 2024 Aluminum Alloy
2024 Aluminum alloy was squeezed cast by the Gas Induced Semi Solid (GISS) process. Effect of artificial aging on microstructure and mechanical properties of this alloy was studied in the present work. The solutionized specimens were aged hardened at temperatures of 175°C, 200°C, and 225°C under various time durations. The highest hardness of about 77.7 HRE was attained from specimen aged at th...
متن کاملsimulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
numerical simulation of abrasive water jet cutting process using the sph and ale methods
on account of some complexities such as fluid-structure interaction and extra-large deformation problems, complete simulation of abrasive water jet cutting process is very hard. the main goal of this paper is to overcome these difficulties through comprehensive simulation in ls-dyna commercial software. for this purpose the smoothed particle hydrodynamics (sph) and arbitrary lagrangian eulerian...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Engineering Science and Military Technologies
سال: 2019
ISSN: 2357-0946
DOI: 10.21608/ejmtc.2019.8057.1104