Experimental measurement of temperature distribution in the chip generated during high speed orthogonal cutting process
نویسندگان
چکیده
منابع مشابه
Chip Formation Process using Finite Element Simulation “Influence of Cutting Speed Variation”
The main aim of this paper is to study the material removal phenomenon using the finite element method (FEM) analysis for orthogonal cutting, and the impact of cutting speed variation on the chip formation, stress and plastic deformation. We have explored different constitutive models describing the tool-workpiece interaction. The Johnson-Cook constitutive model with damage initiation and damag...
متن کاملconsequence analysis of the leakage, ignition and explosion during high pressure sour gas injection process to the oil reservoir
there is no doubt that human being needs to become integrated with industry and industry needs to be progressed, daily. on the other hand, serious events in industrial units specially in oil industries has been shown that such damages and events are industry related ones. the consequence of such events and damages which resulted in chemical and poisoned explosions and loss of life and property ...
Effect of cutting parameters on tool-chip interface temperature in an orthogonal turning process
The aim of this paper is to investigate the effect of cutting speed and uncut chip thickness on cutting performance. A Finite Element Method (FEM) based on the ABAQUS explicit software which involves Johnson-Cook material mode and Coulombs friction law was used to simulate of High Speed Machining (HSM) of AISI 1045 steel. In this simulation work, feed rate ranging from 0.05 mm/rev to 0.13 mm/re...
متن کاملIn situ strain measurement in the chip formation zone during orthogonal cutting
The in situ strain measurements during orthogonal cutting were performed to get information about the local stress state in the chip formation zone. These results will be used to verify and extend existing chip formation models. Until now the existing chip formation models, e.g. [1-3] are relying on a number of restricting preconditions, because the strain and stress fields in the chip formatio...
متن کاملExperimental Study of the Effect of Laser-Cutting Process Parameters on Heat Distribution and Cutting Edge Quality of Steel Sheets
This study aimed to evaluate Laser-cutting process of Mild Steel St37 sheets with two different thicknesses. In order to evaluate the quality of cutting edge and the depth of the area affected by the heat, several tests were conducted to determine the effect of parameters such as Laser power, Laser beam movement speed and pressure of axillary gas on the quality of cutting edge and the depth of ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Machining and Machinability of Materials
سال: 2008
ISSN: 1748-5711,1748-572X
DOI: 10.1504/ijmmm.2008.017624