Experimental Investigations with Crush Box Simulations for Different Segment Cars using LS-DYNA
نویسندگان
چکیده
منابع مشابه
LS-DYNA® Best-Practices: Networking, MPI and Parallel File System Effect on LS-DYNA Performance
From concept to engineering, and from design to test and manufacturing, the automotive industry relies on powerful virtual development solutions. CFD and crash simulations are performed in an effort to secure quality and accelerate the development process. The recent trends in cluster environments, such as multi-core CPUs, GPUs, cluster file systems and new interconnect speeds and offloading ca...
متن کاملModeling Tire Blow-out in Roadside Hardware Simulations Using Ls-dyna
Often when vehicles interact with roadside hardware like guardrails, bridge rails and curbs, the interaction between the roadside hardware and the tire causes the tire to lose its air seal and "blow-out". Once the seal between the rim and rubber tire is lost, the tire deflates. The behavior of the deflated tire is much different than the behavior of an inflated tire such that when this behavior...
متن کاملSimulating laminated composites using LS - DYNA material model
A wide range of composite material forms are finding use in today’s aerospace, automotive, and other transportation industry segments. The Boeing 787 commercial airliner, unveiled in 2007, features over 50% carbon fiber composites by structural weight, while the entire structure of the Lamborghini Sesto Elemento supercar, unveiled in 2011, is made exclusively from carbon fiber composites [1-2]....
متن کاملPre-processor Software for Calibration of LS-DYNA Material Models
LS-DYNA contains a wealth of material models that allow for the simulation of transient phenomena. These models are often quite complex and difficult to calibrate. We present CAE Modeler, a generalized pre-processor software used to convert material property data into material parameters for different material models used in CAE. In this paper, CAE Modeler is used to streamline the conversion o...
متن کاملComparison of forming, welding and heat treatment simulations in LS-DYNA and MSC Marc
The manufacturing of components for aero engine structures from a flat sheet to the final shape usually requires several steps that may introduce residual stresses and shape distortions in the part. Depending on the magnitude, sign and distribution with respect to the stresses induced by the service load, the remaining stresses may affect the service life of a component, especially when submitt...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Current Engineering and Technology
سال: 2010
ISSN: 2277-4106
DOI: 10.14741/ijcet/spl.2.2014.127